Related Experiment Video
Updated: Feb 9, 2026

Isolation and Characterization of the Murine Uterosacral Ligaments and Pelvic Floor Organs
Published on: March 3, 2023
Longitudinal changes in pelvic floor muscle strength among parous women
Emily N B Myer1, Jennifer L Roem2, David A Lovejoy1
1Johns Hopkins School of Medicine, Department of Obstetrics and Gynecology, Division of Female Pelvic Medicine and Reconstructive Surgery, Baltimore, MD.
Background:
There is limited knowledge of the effects of time on change in pelvic floor muscle strength after childbirth.
Objective:
The objectives of this study were to estimate the change in pelvic floor muscle strength in parous women over time and to identify maternal and obstetric characteristics associated with the rate of change.
Study Design:
This is an institutional review board-approved prospective cohort study of parous women. Participants were recruited 5-10 years after first delivery and followed annually. Pelvic floor muscle strength (peak pressure with voluntary contraction) was measured at 2 annual visits approximately 4 years apart with the use of a perineometer. We calculated the change in peak pressures, which were standardized per 5-year interval. Linear regression was used to identify maternal and obstetric characteristics that are associated with the rate of change in peak pressure. The obstetric variable of greatest interest was delivery group. Participants were classified into 3 delivery groups (considering all deliveries for each multiparous woman). Delivery categories included cesarean only, at least 1 vaginal birth but no forceps-assisted deliveries, and at least 1 forceps-assisted vaginal birth. Statistical analysis was completed with statistical software.
Results:
Five hundred forty-three participants completed 2 perineometer measurements with a median 4 years between measures (interquartile range, 3.1-4.8). At initial measurement, women were, on average, 40 years old and 8 years from first delivery. Initial strength was higher in participants who delivered all their children by cesarean (38.5 cm H2O) as compared with women with any vaginal non-forceps delivery (26.0 cm H2O) or vaginal forceps delivery (13.5 cm H2O; P<.001). There was a strong correlation between the first and second perineometry measurement (r=0.84). Median change in pelvic floor muscle strength was small at 1.2 cm H2O per 5 years (interquartile range, -5.6, 9.9 cm H2O). In multivariable analysis, women who delivered by cesarean only demonstrated almost no change in strength over 5 years (0.2 increase cm H2O per 5 years); those who experienced at least 1 vaginal or vacuum delivery increased strength (4.8 cm H2O per 5 years) as did women with at least 1 forceps delivery (5.0 cm H2O per 5 years). Additionally, obese women had a significant reduction in strength (-3.1 cm H2O per 5 years) compared with normal weight participants (0.2 cm H2O per 5 years).
Conclusion:
Among parous women, pelvic muscle strength increased minimally over time with an average change of 1.2 cm H2O per 5 years; change in strength was associated with mode of delivery and obesity.
Related Concept Videos
Muscles of the Pelvic Floor and Perineum
Perineal Layer
The perineum is a diamond-shaped area below the pelvic diaphragm, divided into an anterior urogenital triangle that contains the external genitals and a posterior anal triangle housing the anus. The urogenital...
Longitudinal Research
Acid Strength and Molecular Structure
In the absence of any leveling effect, the acid strength of binary compounds of hydrogen with nonmetals (A) increases as the H-A bond strength decreases down a group in the periodic table. For group 17, the order of increasing acidity is HF < HCl < HBr < HI. Likewise, for group 16, the order of increasing acid strength is H2O < H2S < H2Se < H2Te. Across a row in the periodic table, the acid strength of binary hydrogen compounds increases with increasing...
Longitudinal Studies
Strength of Cement
For compressive strength tests, ASTM C 109-05 standards prescribe a cement-sand mix ratio of 1:2.75 and a water/cement ratio of 0.485 for making 2-inch cubes. These cubes are mixed, cast, and cured in saturated lime water at 23°C until testing. Flexural strength testing, outlined in...
Relation Between Tensile Strength and Compressive Strength of Concrete

