Study on the simultaneous reduction of methylmercury by SnCl₂ when analyzing inorganic Hg in aqueous samples

Mercury (Hg) is among the most concerned contaminants in the world. It has three major chemical forms in the environment, including Hg⁰, Hg²⁺, and methylmercury (MeHg). Due to their differences in toxicity, mobility, and bioavailability, speciation analysis is critical for understanding Hg cycling and fate in the environment. SnCl₂ reduction-atomic fluorescence spectrometry detection is the most commonly used method for analyzing inorganic Hg. However, it should be noted that MeHg may also be reduced by SnCl₂, which would result in the overestimation of inorganic Hg. In this study, the reduction of MeHg by SnCl₂ in both de-ionized (DI) water and four natural waters was investigated. The results showed that MeHg could be reduced by SnCl₂ in DI water whereas this reaction was hard to occur in tested natural waters. By investigating the effects of water chemical characteristics (dissolved organic matter, pH and common anions and cations) on this reaction, SO₄^2- was identified to be the dominant factor prohibiting SnCl₂ induced MeHg reduction in natural waters. SO₄^2- in natural waters was evidenced to be reduced to S^2- by SnCl₂ and the generated S^2- can complex with MeHg to form MeHgS^- which is hard to be reduced by SnCl₂. Findings of this study indicate that the effect of MeHg reduction by SnCl₂ on inorganic Hg analysis is negligible in natural waters; however, at simulated experimental systems without SO₄^2-, SO₄^2- should be added as protecting agents to prevent MeHg reduction when analyzing inorganic Hg if it would not cause any other unwanted effects.