Simultaneous and stoichiometric purification of hundreds of oligonucleotides

Alessandro Pinto1, Sherry X Chen1, David Yu Zhang2

  • 1Department of Bioengineering, Rice University, Houston, 77005, TX, USA.

Nature Communications
|June 27, 2018
PubMed

Related Concept Videos

Detergent Purification of Membrane Proteins01:18

Detergent Purification of Membrane Proteins

Detergents are used to purify the integral proteins of the membrane. The hydrophobic portion of the detergent can replace membrane phospholipids while solubilizing the membrane proteins. When detergent monomers reach a specific concentration in a solution called critical micelle concentration (CMC), they form micelles. Above CMC, the concentration of the detergent monomers remains in equilibrium with the micelle. The number of detergent monomers present in the CMC varies for each detergent, and...
6.5K
Chemical Stoichiometry and Gases: Using Ideal Gas Law to Determine Moles03:12

Chemical Stoichiometry and Gases: Using Ideal Gas Law to Determine Moles

Chemical stoichiometry describes the quantitative relationships between reactants and products in chemical reactions.
30.0K
Limiting Reactant02:27

Limiting Reactant

The relative amounts of reactants and products represented in a balanced chemical equation are often referred to as stoichiometric amounts. However, in reality, the reactants are not always present in the stoichiometric amounts indicated by the balanced equation.
70.2K
Calculating pH Changes in a Buffer Solution02:45

Calculating pH Changes in a Buffer Solution

A buffer can prevent a sudden drop or increase in the pH of a solution after the addition of a strong acid or base up to its buffering capacity; however, such addition of a strong acid or base does result in the slight pH change of the solution. The small pH change can be calculated by determining the resulting change in the concentration of buffer components, i.e., a weak acid and its conjugate base or vice versa. The concentrations obtained using these stoichiometric calculations can be used...
58.8K
Hess's Law03:40

Hess's Law

There are two ways to determine the amount of heat involved in a chemical change: measure it experimentally, or calculate it from other experimentally determined enthalpy changes. Some reactions are difficult, if not impossible, to investigate and make accurate measurements for experimentally. And even when a reaction is not hard to perform or measure, it is convenient to be able to determine the heat involved in a reaction without having to perform an experiment.
55.7K
Homogeneous Equilibria for Gaseous Reactions02:15

Homogeneous Equilibria for Gaseous Reactions

Homogeneous Equilibria for Gaseous Reactions
For gas-phase reactions, the equilibrium constant may be expressed in terms of either the molar concentrations (Kc) or partial pressures (Kp) of the reactants and products. A relation between these two K values may be simply derived from the ideal gas equation and the definition of molarity. According to the ideal gas equation:
29.3K