Unique static discharge events on two CentriMag® (2nd Gen) ECMO patients causing console failure

Robert K Wise1, Sherry M Waldhausen1, Van T Nguyen2

  • 11 Penn State Hershey Medical Center, Penn State Health, Hershey, PA, USA.

Perfusion
|June 30, 2018
PubMed
Summary

Two CentriMag console failures during patient transport were linked to a non-approved mounting rod causing static discharge. Removing the rod resolved the issue, preventing patient complications and further pump failures.

Related Concept Videos

Other Unique Bacteria01:18

Other Unique Bacteria

Magnetic bacteria exhibit a directed movement called magnetotaxis, driven by structures called magnetosomes. These magnetosomes consist of chains of magnetic particles made of either magnetite (Fe₃O₄) or greigite (Fe₃S₄) and are organized in a linear conformation by a protein scaffold within invaginations of the cell membrane. The bacteria align along the north–south magnetic field lines, much like a compass needle. They are typically microaerophilic or anaerobic...
449
Discharge Summary Forms01:31

Discharge Summary Forms

The discharge summary is crucial as it enables a smooth transition from a healthcare facility to a patient's home or another care setting. This critical document facilitates seamless continuity of care, ensuring patients receive the necessary support and attention.
Here's a detailed look at the key components and guidelines for preparing a discharge summary:
1.3K
Second Uniqueness Theorem01:16

Second Uniqueness Theorem

Consider a region consisting of several individual conductors with a definite charge density in the region between these conductors. The second uniqueness theorem states that if the total charge on each conductor and the charge density in the in-between region are known, then the electric field can be uniquely determined.
In contrast, consider that the electric field is non-unique and apply Gauss's law in divergence form in the region between the conductors and the integral form to the surface...
2.7K
Design Example: Vintage Mixing Console01:17

Design Example: Vintage Mixing Console

A sound engineer at a music company recently encountered a problem. The output from their newly acquired studio's vintage mixing console was too low for the requirements of modern recording equipment. To rectify this situation, the engineer decided to design an audio pre-amplifier using an operational amplifier (op-amp) to boost the signal level.
The specifications for the pre-amplifier were clear. It needed to amplify the audio signal by a factor of 10, have an input impedance above 10...
587
Static Equilibrium - I01:05

Static Equilibrium - I

A rigid body is said to be in dynamic equilibrium when both its linear and angular acceleration are zero, relative to an inertial frame of reference. This means that a body in equilibrium can be moving, but only when its linear and angular velocities are constant. A rigid body is said to be in static equilibrium when it is at rest in the selected frame of reference. The distinction between static equilibrium (e.g., a state of rest) and dynamic equilibrium (e.g, a state of uniform motion) is...
18.9K
Static Equilibrium - II01:07

Static Equilibrium - II

Static equilibrium is a special case in mechanics that is very important in everyday life. It occurs when the net force and the net torque on an object or system are both zero. This means that both the linear and angular accelerations are zero. Thus, the object is at rest, or its center of mass is moving at a constant velocity. However, this does not mean that no forces are acting on the object within the system. In fact, there are very few scenarios on Earth in which no forces are acting upon...
10.0K