Optimization of TiC Content during Fabrication and Mechanical Properties of Ni-Ti-Al/TiC Composites Using Mixture...

Ni-Ti-Al alloys are highly promising materials for use in high-temperature structural materials. However, minimal research has been conducted to improve the associated mechanical properties through secondary phase addition. In this study, Ni-Ti-Al/TiC composites were fabricated at a pressure of 40 MPa and a sintering temperature of 1050 °C using spark plasma sintering. The microstructure and interfacial structure were analyzed by scanning electron microscopy, energy dispersive X-ray spectroscopy, and X-ray diffraction analysis. Microscopic analysis revealed that TiC particles interacted with Ti and Al, resulting in the formation of Ti₂AlC, which promoted chemical metallurgical bonding between the Ni⁻Ti⁻Al alloy and TiC. Wear characteristics were measured using the wear test with a ball on disk. It was confirmed that the 40 wt % specimen had the highest hardness due to pores generated inside, but the wear amount was relatively high. The mixture design of a minitap was proceeded using hardness, bending strength, and wear loss. An optimum composition ratio of 32.16 wt % was determined using the composite desirability of the three properties.