Evaluation of a Fluorescence-aided Identification Technique (FIT) for removal of composite bonded trauma splints

Accurate removal of composite bonded titanium trauma splints (TTS) can be challenging. The aim of this study was to evaluate a Fluorescence-aided Identification Technique (FIT) compared with a conventional light source (CT) for removal of trauma splints regarding loss of tooth substance, residual composite, and time taken.

Twenty maxillary models with six bovine teeth (13 - 23) were fabricated. An optical three-dimensional impression was taken and a TTS was applied from 12 to 22 with two bonding sites on every tooth under standardized conditions using an etch-and-rinse adhesive and resin composite. Two operators removed 10 splints each (5x FIT and 5x CT). For FIT, a 405 nm light-emitting headlamp was used. Time was recorded. A post-operative scan was superimposed on the pre-operative scan using OraCheck software. A qualitative and quantitative analysis of tooth defects and composite remnants was performed by two operators and statistically analyzed.

Compared with the CT, FIT led to significantly fewer and smaller enamel defects (mean volume: -0.04 mm³ vs -0.33 mm³ ) (P < 0.001), significantly less composite remained (mean volume: 0.02 mm³ vs 0.28 mm³ ) (P < 0.001), and the removal procedure with FIT was significantly quicker (mean: 162 seconds vs 268 seconds) (P < 0.001), CONCLUSIONS: FIT facilitated the removal of composite used to bond trauma splints leading to less time-consuming as well as less invasive treatment. It left fewer composite residues on enamel surfaces.