Influence of inoculum size, incubation temperature, and cell culture density on virus detection in environmental...

The influence of inoculum size and cell culture density on virus titer by cytopathic effect or plaque assay was studied using poliovirus type 1 and BGM (Buffalo green monkey) cells as a model for this evaluation. With a plaque assay system, a linear relationship was observed for an inoculum size of up 1 mL/25 cm2; a marked decrease in the number of plaques was observed when over 1 mL of sample was inoculated on this surface area. Cell culture density also affected virus titer; maximal titers were observed when cells were seeded at 25 000 to 75 000 cells/mL and incubated for 6 days before infection with the virus. Viral density, evaluated as most-probable-number and measured by cytopathic effect under liquid overlay, revealed that the viral titer was similar up to 1 mL inoculum and increased only when over 1 mL was inoculated. Cell density had no significant effect on the viral titer measured by the most-probable-number method and cytopathic effect. Inactivation of inoculum due to an incubation temperature of 37 degrees C for a short period was shown to be minimal for poliovirus type 1, reovirus type 2, coxsackievirus B-5, and the simian rotavirus SA-11. Longer inactivation time led to a 2 logs reduction of the infectious titer of coxsackievirus B-5 (in 48 h) while the other viruses showed a significant reduction in titer only after 96 h.