Related Experiment Video
Updated: Feb 7, 2026

Author Spotlight: Tracking Electrochemistry on Single Nanoparticles with Surface-Enhanced Raman Scattering Spectroscopy and Microscopy
Published on: May 12, 2023
Deep-ultraviolet Raman scattering spectroscopy of monolayer WS2
Hsiang-Lin Liu1, Teng Yang2,3, Yuki Tatsumi4
1Department of Physics, National Taiwan Normal University, Taipei, 11677, Taiwan. hliu@ntnu.edu.tw.
Abstract:
Raman scattering measurements of monolayer WS2 are reported as a function of the laser excitation energies from the near-infrared (1.58 eV) to the deep-ultraviolet (4.82 eV). In particular, we observed several strong Raman peaks in the range of 700∼850 cm-1 with the deep-ultraviolet laser lights (4.66 eV and 4.82 eV). Using the first-principles calculations, these peaks and other weak peaks were appropriately assigned by the double resonance Raman scattering spectra of phonons around the M and K points in the hexagonal Brillouin zone. The relative intensity of the first-order [Formula: see text] to A1g peak changes dramatically with the 1.58 eV and 2.33 eV laser excitations, while the comparable relative intensity was observed for other laser energies. The disappearance of the [Formula: see text] peak with the 1.58 eV laser light comes from the fact that valley polarization of the laser light surpasses the [Formula: see text] mode since the [Formula: see text] mode is the helicity-exchange Raman mode. On the other hand, the disappearance of the A1g peak with the 2.33 eV laser light might be due to the strain effect on the electron-phonon matrix element.
Related Concept Videos
Raman Spectroscopy: Overview
However, a small fraction of the scattered light exhibits a frequency shift due to the exchange of energy between the incident photons and...
Ultraviolet and Visible (UV–Vis) Spectroscopy: Overview
Raman Spectroscopy Instrumentation: Overview
The monochromatic laser source, typically using visible or near-infrared radiation, generates a highly focused beam of light. This light interacts with the molecules of the sample, scattering some of the light. Liquid and gaseous samples are usually tested in ordinary glass capillaries, while solids can be analyzed as powders packed in capillaries or as potassium...
Scatter Plot
Atomic Fluorescence Spectroscopy
Infrared (IR) Spectroscopy: Overview
Different compounds display unique properties due to their...

