Related Experiment Video
Updated: Feb 6, 2026

03:27
The Role of Indocyanine Green Fluorescence in Complex Laparoscopic Cholecystectomy Navigation
Published on: January 31, 2025
1.3K
Elective cholecystectomy after reversal of septic shock using multimodality endoscopic gallbladder drainage
Pietro Fusaroli1, Marta Serrani1, Sandro Sferrazza1
1Gastroenterology Unit, Department of Medical and Surgical Sciences University of Bologna, Hospital of Imola, Imola, Italy.
Endoscopy
|August 15, 2018
Abstract
No abstract available in PubMed .
Related Concept Videos
Gallbladder
2.3K
The gallbladder is a small, pear-shaped organ that plays a crucial role in our digestive system. Measuring about 10 cm in length, it is comparable in size to a kiwi fruit and is located in a hollow area on the lower surface of the liver. The gallbladder's primary function is to store and concentrate bile, a fluid produced by the liver that aids in digestion.
The gallbladder's anatomy consists of three regions: the fundus, body, and neck. Extending from the neck, the cystic duct joins...
The gallbladder's anatomy consists of three regions: the fundus, body, and neck. Extending from the neck, the cystic duct joins...
2.3K
Diseases of the Liver and Gallbladder
2.0K
Liver and gallbladder diseases are a significant health concern, with prominent conditions including cirrhosis, hepatitis, non-alcoholic fatty liver disease (NAFLD), and gallstones. Jaundice is a common manifestation of liver and biliary disease.
Cirrhosis is characterized by the scarring of hepatic lobules in the liver, which are replaced by fibrous tissue, affecting the liver's normal functioning. NAFLD, on the other hand, is caused by an excessive build-up of fat in the liver, not...
Cirrhosis is characterized by the scarring of hepatic lobules in the liver, which are replaced by fibrous tissue, affecting the liver's normal functioning. NAFLD, on the other hand, is caused by an excessive build-up of fat in the liver, not...
2.0K
Shock Waves
2.6K
While deriving the Doppler formula for the observed frequency of a sound wave, it is assumed that the speed of sound in the medium is greater than the source's speed through it. When this condition is breached, a shock wave occurs.
When the source's speed approaches the speed of sound, constructive interference between successive wavefronts emitted by the source occurs immediately behind it. Initially, scientists believed that this constructive interference would result in such high...
When the source's speed approaches the speed of sound, constructive interference between successive wavefronts emitted by the source occurs immediately behind it. Initially, scientists believed that this constructive interference would result in such high...
2.6K
Cavity Drainage and Flashings in Masonry walls
471
Typically, a cavity wall consists of two wythes separated by a gap of at least 2 inches, which may contain insulation while still maintaining a minimum clear space of 1 inch to facilitate adequate drainage. Advanced methods like the insertion of a continuous drainage mat can further reduce this space while ensuring effective moisture expulsion.
Weep holes, strategically placed at the base of the cavity, are critical for draining accumulated water. These openings are created by leaving head...
Weep holes, strategically placed at the base of the cavity, are critical for draining accumulated water. These openings are created by leaving head...
471
Reversible and Irreversible Processes
5.8K
The thermodynamic processes can be classified into reversible and irreversible processes. The processes that can be restored to their initial state are called reversible processes. It is only possible if the process is in quasi-static equilibrium, i.e., it takes place in infinitesimally small steps, and the system remains at equilibrium However, these are ideal processes and do not occur naturally. An ideal system undergoing a reversible process is always in thermodynamic equilibrium within...
5.8K
Diode: Reverse bias
2.0K
A diode is reverse-biased when the positive terminal of an external voltage source is connected to the n-type material and the negative terminal to the p-type material. This configuration opposes the natural direction of current flow through the diode, effectively increasing the width of the depletion region and the barrier potential. The reverse bias condition produces a minimal leakage current, primarily due to minority charge carriers. This leakage becomes significant when the reverse...
2.0K

