Related Experiment Video
Updated: Feb 6, 2026

Inkjet-printed Polyvinyl Alcohol Multilayers
Published on: May 11, 2017
Nanocomposites containing polyvinyl alcohol and reinforced carbon-based nanofiller: A super effective biologically
Khdejah S Hajeeassa1, Mahmoud A Hussein1,2, Yasir Anwar3
1Chemistry Department, Faculty of Science, King Abdulaziz University, Jeddah, Kingdom of Saudi Arabia.
Abstract:
A new class of biologically active polymer nanocomposites based on polyvinyl alcohol and reinforced mixed graphene/carbon nanotube as carbon-based nanofillers with a general abbreviation (polyvinyl alcohol/mixed graphene-carbon nanotubes) has been successfully synthesized by an efficient solution mixing method with the help of ultrasonic radiation. Mixed graphene and carbon nanotubes ratio has been prepared (50%:50%) wt by wt. Different loading of mixed graphene-carbon nanotubes (2, 5, 10, 15, and 20 wt%) were added to the host polyvinyl alcohol polymer. In this study, polyvinyl alcohol/mixed graphene-carbon nanotubesa-e nanocomposites were characterized and analyzed by X-ray diffraction, Fourier transform infrared, scanning electron microscopy, transmission electron microscopy, and the thermal stability was measured by thermogravimetric analysis and derivative thermal gravimetric. Fourier transform infrared and X-ray diffraction spectra proved the addition of mixed graphene-carbon nanotubes into polyvinyl alcohol matrix. X-ray diffraction patterns for these nanocomposites showed 2θ = 19.35° and 40° due to the crystal nature of polyvinyl alcohol in addition to 2θ = 26.5° which attributed to the graphite plane of carbon-based nanofillers. Thermal stability of polyvinyl alcohol/mixed graphene-carbon nanotubes nanocomposites was enhanced comparing with pure polyvinyl alcohol. The main degradation step ranged between 360° and 450°C. Moreover, maximum composite degradation temperature has appeared at range from 285°C to 267°C and final composite degradation temperature (FCDT) displayed at a temperature range of 469-491°C. Antibacterial property of polyvinyl alcohol/mixed graphene-carbon nanotubesa-e nanocomposites were tested against Escherichia coli bacteria using the colony forming units technique. Results showed an improvement of antibacterial property. The rate percentages of polyvinyl alcohol/mixed graphene-carbon nanotubesb, polyvinyl alcohol/mixed graphene-carbon nanotubesc, and polyvinyl alcohol/mixed graphene-carbon nanotubesd nanocomposites after 24 h are 6%, 5%, and 7% respectively. However, polyvinyl alcohol/mixed graphene-carbon nanotubese nanocomposite showed hyperactivity, where its reduction percentage remarkably raised up to 100% which is the highest inhibition rate percentage. In addition, polyvinyl alcohol and polyvinyl alcohol/graphene-carbon nanotubesa-d showed colony forming units values/ml 70 × 106 and 65 ± 2 × 106 after 12 h. After 24 h, the colony forming units values/ml were in the range of 86 × 106-95 × 106.
Related Concept Videos
Biological Effects of Radiation
Reinforcement
Positive reinforcement occurs when a behavior is followed by the presentation of a rewarding stimulus, increasing the frequency of that behavior. For example:
Introduction to Biological Bases of Psychology
The nervous system, the cornerstone of...
The Carbon Cycle
What is Conservation Biology?
Corrosion of Reinforcement
However, over time and under certain conditions like carbonation, chloride ingress, and cracking this protective state can be compromised. Steel has areas with...

