Related Experiment Video

Updated: Feb 5, 2026

Utilizing Percutaneous Ventricular Assist Devices in Acute Myocardial Infarction Complicated by Cardiogenic Shock
06:10

Utilizing Percutaneous Ventricular Assist Devices in Acute Myocardial Infarction Complicated by Cardiogenic Shock

Published on: June 12, 2021

3.7K

Prognostic impact of baseline and residual SYNTAX scores in cardiogenic shock

Tuija Javanainen1, Jordi Sans-Roselló2, Veli-Pekka Harjola3

  • 1Cardiology, University of Helsinki, Heart and Lung Center, Helsinki University Hospital, Helsinki, Finland.

Catheterization and Cardiovascular Interventions : Official Journal of the Society for Cardiac Angiography & Interventions
|September 13, 2018
PubMed
Abstract

Keywords:
acute coronary syndromeprognosisrevascularizationshock

More Related Videos

Use of a Percutaneous Ventricular Assist Device/Left Atrium to Femoral Artery Bypass System for Cardiogenic Shock07:39

Use of a Percutaneous Ventricular Assist Device/Left Atrium to Femoral Artery Bypass System for Cardiogenic Shock

Published on: August 16, 2021

4.1K
Inverse Probability of Treatment Weighting Propensity Score using the Military Health System Data Repository and National Death Index06:55

Inverse Probability of Treatment Weighting Propensity Score using the Military Health System Data Repository and National Death Index

Published on: January 8, 2020

15.4K

Related Concept Videos

Residual Plots01:07

Residual Plots

A residual plot is a statistical representation of data used to analyze correlation and regression results. It helps verify the requirements for drawing specific conclusions about correlation and regression. To obtain the residual plot, first, the residual for each data value is calculated, which is simply the vertical distance between the observed and the predicted value obtained from the regression equation.
When the residual values are plotted against the variable x, it is called a residual...
6.5K
Residual Stresses01:26

Residual Stresses

Residual stresses reside in a structure even after removing the original stress inducer. This phenomenon often arises from varied plastic deformations across different parts of a structure. Consider a rod stretched beyond its yield point. It will not regain its original length due to permanent deformation. Even after load removal, the rod does not entirely lose stress because of uneven plastic deformations, resulting in residual stresses. The computation of these stresses in structures is...
650
Introduction to z Scores01:06

Introduction to z Scores

A z score (or standardized value) is measured in units of the standard deviation. It tells you how many standard deviations the value x is above (to the right of) or below (to the left of) the mean, μ. Values of x that are larger than the mean have positive z scores, and values of x that are smaller than the mean have negative z scores. If x equals the mean, then x has a zero z score. It is important to note that the mean of the z scores is zero, and the standard deviation is one.
z scores...
11.2K
Introduction to z Scores01:05

Introduction to z Scores

A z score (or standardized value) is measured in units of the standard deviation. It indicates how many standard deviations the value x is above (to the right of) or below (to the left of) the mean, μ. Values of x that are larger than the mean have positive z scores, and values of x that are smaller than the mean have negative z scores. If x equals the mean, then x has a zero z score. It is important to note that the mean of the z scores is zero, and the standard deviation is one.
z scores...
1.4K
z Scores and Area Under the Curve01:17

z Scores and Area Under the Curve

z scores are the standardized values obtained after converting a normal distribution into a standard normal distribution. A z score is measured in units of the standard deviation. The z score tells you how many standard deviations the value x is above (to the right of) or below (to the left of) the mean, μ. Values of x that are larger than the mean have positive z scores, and values of x that are smaller than the mean have negative z scores. If x equals the mean, then x has a z score of...
19.6K
Shock Waves01:16

Shock Waves

While deriving the Doppler formula for the observed frequency of a sound wave, it is assumed that the speed of sound in the medium is greater than the source's speed through it. When this condition is breached, a shock wave occurs.
When the source's speed approaches the speed of sound, constructive interference between successive wavefronts emitted by the source occurs immediately behind it. Initially, scientists believed that this constructive interference would result in such high...
2.6K