Related Experiment Video
Updated: Feb 5, 2026

Monitoring Lung Function with Electrical Impedance Tomography in the Intensive Care Unit
Published on: September 6, 2024
Variation in Gentamicin Dosing and Monitoring in Pediatric Units across New South Wales
Vishal Saddi1, John Preddy1, Sarah Dalton1
1Department of Paediatrics, Sydney Children's Hospital, Randwick; Discipline of Paediatrics and Child Health, University of New South Wales, Rural Medical School, Wagga Wagga; and Clinical Excellence Commission, Sydney, New South Wales, Australia.
Introduction:
Gentamicin is an aminoglycoside antibiotic with broad-spectrum bactericidal activity and is widely used in pediatric units to treat infection with susceptible organisms. This study aimed to describe the dosage regimen for gentamicin and approach to its therapeutic drug monitoring (TDM) among the pediatric units within the state of New South Wales (NSW).
Methods:
A questionnaire was sent electronically to representatives of 40 pediatric units in NSW, requesting details of each unit's gentamicin dosing and TDM policy.
Results:
A total of 35 units responded to the survey. The majority (63%) of the units used a dose of 7.5 mg/kg of gentamicin in patients with normal renal function. More than half of the units (54%) did not have a local gentamicin dosing protocol and relied on other sources for dosing regimens. Dosing responses varied from a dose of 6 mg/kg once daily for patients more than 10 years of age to 7 mg/kg once daily on day 1, followed by 5 mg/kg once daily for patients over 10 years of age. For TDM of gentamicin, 63% of units indicated use of trough levels and 23% units used the Hartford Nomogram.
Conclusions:
A significant variation exists in clinical practice among pediatric units in NSW on gentamicin dosing and TDM guidelines. There is an urgent need for collaboration among nursing, medical, and pharmacy experts to achieve consensus to develop and adopt statewide uniform guidelines on gentamicin dosing and TDM.
Related Concept Videos
What is Variation?
The range, standard deviation, standard error, and variance are the different measures of variation.
Range: The range is the difference between its maximum and...
Variation
When independent and dependent variables are plotted on a scatter plot, the slope of a line is a value that describes the rate of change between the two...
Measurement: Standard Units
Measurement: Derived Units
Conservative Site-specific Recombination and Phase Variation
The recognition sites for Cre recombinase called LoxP...
Variation of Atmospheric Pressure
Assuming the air temperature is constant at a given altitude and that the ideal gas law of thermodynamics describes the atmosphere to a good approximation, one can find the variation of atmospheric pressure with height.
Let p(y) be the atmospheric pressure at...

