Related Experiment Video
Updated: Feb 4, 2026
Investigating Long-Distance Transport of Perfluoroalkyl Acids in Wheat via a Split-Root Exposure Technique
Published on: September 28, 2022
Solubility and pH Value of 3 Different Root Canal Sealers: A Long-term Investigation
Kent Urban1, Julian Neuhaus1, David Donnermeyer1
1Department of Periodontology and Operative Dentistry, Westphalian Wilhelms-University, Münster, Germany.
Introduction:
The aim of this study was to compare the solubility and the change in pH of a tricalcium silicate-containing sealer (BioRoot RCS [BR]), a mineral trioxide aggregate-containing sealer (MTA Fillapex [MTA]), and an epoxy resin-based sealer (AH Plus [AH]) during a longer period of time.
Methods:
The solubility test was carried out in accordance with ISO6876:2012. Three hundred eighty sealer samples (n = 10 per group) were stored for 6 months in double distilled water (AD) or phosphate-buffered saline (PBS). The solubility was determined on the basis of the mass difference in percent. The pH measurement was carried out on the basis of the experimental setup of the solubility test with the aid of an electrode pH meter. The results were evaluated for significance by using analysis of variance, Student-Newman-Keuls, and t test (P < .05).
Results:
The highest solubility was found for MTA in AD (4.65% ± 1.17%), followed by BR in AD (3.88% ± 0.42%) (P < .05). Also in PBS, MTA (3.24% ± 0.7%) showed a higher solubility than BR (1.78% ± 0.5%) (P < .05). AH was virtually insoluble during the entire period (0.5% ± 0.5%) (P < .05). The pH decreased continuously over time for all samples. After 6 months, BR showed the highest pH in AD (pH 10.3), followed by MTA in AD (pH 8.8), BR in PBS (pH 7.5), AH in PBS (pH 7.3), MTA in PBS (pH 7.2), and AH in AD (pH 6.3).
Conclusions:
The solubility of MTA was significantly increased compared with BR and AH. Storage in PBS significantly reduced solubility of MTA and BR. BR showed a higher pH in both AD and PBS than MTA in AD and PBS. AH did not cause any significant pH change.
Related Concept Videos
03:07Solubility Equilibria
The...
04:01Factors Affecting Solubility
02:55Solubility of Ionic Compounds
02:19Physical Properties Affecting Solubility
As for any solution, the solubility of a gas in a liquid is affected by the attractive intermolecular forces between solute and solvent species. Unlike solid and liquid solutes, however, there is no solute-solute intermolecular attraction to overcome when a gaseous solute dissolves in a liquid solvent since the atoms or molecules comprising a gas are far separated and experience negligible interactions. Consequently, solute-solvent interactions are the sole...
03:00Solubility
A solution is a homogeneous mixture composed of a solvent, the major component, and a solute, the minor component. The physical state of a solution—solid, liquid, or gas—is typically the same as that of the solvent. Solute concentrations are often described with qualitative terms such as dilute (of relatively low concentration) and concentrated (of relatively high concentration).
In a solution, the solute particles (molecules,...
01:05Long-term Depression