Favorable outcomes of prepackaged low-residue diet on bowel preparation for colonoscopy: Endoscopist-blinded

Jung Won Lee1, Joon Young Choi2, Hyuk Yoon2

  • 1Department of Internal Medicine, Samsung Changwon Hospital, Sungkyunkwan University School of Medicine, Changwon, Korea.

Abstract

Related Concept Videos

Blind Procedures02:07

Blind Procedures

Ideally, the people who observe and record the children’s behavior are unaware of who was assigned to the experimental or control group, in order to control for experimenter bias. Experimenter bias refers to the possibility that a researcher’s expectations might skew the results of the study. Remember, conducting an experiment requires a lot of planning, and the people involved in the research project have a vested interest in supporting their hypotheses. If the observers knew which...
13.5K
Blinding01:11

Blinding

Blinding is a commonly used method of not telling participants which treatment a subject is receiving. Blinding is a critical part of a randomized control trial or RCT. It reduces the bias that affects the results. In an RCT, blinding is used in the form of a placebo. A placebo effect occurs when untreated subjects falsely believe they have received the treatment and report improved symptoms. A placebo or a dummy treatment is administered to subjects to negate the bias caused by such an effect.
4.0K
Endoscopic Procedures II: Colonoscopy01:25

Endoscopic Procedures II: Colonoscopy

The colon, or large intestine, is the final segment of the digestive system. Its primary functions include absorbing water and vitamins produced by gut bacteria and transforming waste from liquid to solid to form stool. In adults, the large intestine is approximately 5 feet long and consists of four main sections:
752
Residual Plots01:07

Residual Plots

A residual plot is a statistical representation of data used to analyze correlation and regression results. It helps verify the requirements for drawing specific conclusions about correlation and regression. To obtain the residual plot, first, the residual for each data value is calculated, which is simply the vertical distance between the observed and the predicted value obtained from the regression equation.
When the residual values are plotted against the variable x, it is called a residual...
6.5K
Residual Stresses01:26

Residual Stresses

Residual stresses reside in a structure even after removing the original stress inducer. This phenomenon often arises from varied plastic deformations across different parts of a structure. Consider a rod stretched beyond its yield point. It will not regain its original length due to permanent deformation. Even after load removal, the rod does not entirely lose stress because of uneven plastic deformations, resulting in residual stresses. The computation of these stresses in structures is...
648
Gibbs Free Energy and Thermodynamic Favorability02:23

Gibbs Free Energy and Thermodynamic Favorability

The spontaneity of a process depends upon the temperature of the system. Phase transitions, for example, will proceed spontaneously in one direction or the other depending upon the temperature of the substance in question. Likewise, some chemical reactions can also exhibit temperature-dependent spontaneities. To illustrate this concept, the equation relating free energy change to the enthalpy and entropy changes for the process is considered:
8.2K