A novel solution for freezing small numbers of spermatozoa using a sperm vitrification device

Arie Berkovitz1,2,3, Netanella Miller1,2, Michal Silberman4,5

  • 1Department of Gynecology and Obstetrics, Meir Medical Center, 59 Tchernichovsky St, Kfar Saba, Israel.

Abstract

Related Concept Videos

Freezing Point Depression and Boiling Point Elevation03:12

Freezing Point Depression and Boiling Point Elevation

Boiling Point Elevation
The boiling point of a liquid is the temperature at which its vapor pressure is equal to ambient atmospheric pressure. Since the vapor pressure of a solution is lowered due to the presence of nonvolatile solutes, it stands to reason that the solution’s boiling point will subsequently be increased. Vapor pressure increases with temperature, and so a solution will require a higher temperature than will pure solvent to achieve any given vapor pressure, including one...
40.2K
Sperm Transport01:15

Sperm Transport

The journey of sperm from its origin to the point of ejaculation begins within the seminiferous tubules of the testis. Here, Sertoli cells produce fluid that propels non-motile sperm through a series of conduits, starting with the straight tubules leading to the rete testis. This interconnected network of tubules acts as the initial pathway for sperm, guiding them into the efferent ductules and then into the epididymis for maturation.
The maturation phase occurs in the epididymis, where sperm...
3.5K
Phase Transitions: Melting and Freezing02:39

Phase Transitions: Melting and Freezing

Heating a crystalline solid increases the average energy of its atoms, molecules, or ions, and the solid gets hotter. At some point, the added energy becomes large enough to partially overcome the forces holding the molecules or ions of the solid in their fixed positions, and the solid begins the process of transitioning to the liquid state or melting. At this point, the temperature of the solid stops rising, despite the continual input of heat, and it remains constant until all of the solid is...
15.2K
Ideal Solutions02:24

Ideal Solutions

According to Raoult’s law, the partial vapor pressure of a solvent in a solution is equal or identical to the vapor pressure of the pure solvent multiplied by its mole fraction in the solution. However, Raoult's Law is only valid for ideal solutions. For a solution to be ideal, the solvent-solute interaction must be just as strong as a solvent-solvent or solute-solute interaction. This suggests that both the solute and the solvent would use the same amount of energy to escape to the...
22.5K
General Properties of Solutions02:12

General Properties of Solutions

Many common substances around us exist as a solution, such as ocean water, air, and gasoline. All solutions are mixtures of substances that are composed of varying amounts of two or more types of atoms or molecules. A mixture with a non-uniform composition is a heterogeneous mixture, whereas a mixture with a uniform composition is a homogeneous mixture. The components that make the homogeneous mixture are evenly spread out and thoroughly mixed. 
35.8K
Solution Formation02:16

Solution Formation

There is no one solvent that can dissolve every type of solute. Some substances that readily dissolve in a certain solvent might be insoluble in a different solvent. A simple way to predict which substances dissolve in which solvent is the phrase "like dissolves like". This means that polar substances, such as salt and sugar, dissolve in a polar substance like water. In contrast, non-polar substances are more soluble in non-polar solvents such as carbon tetrachloride.
This selective...
37.7K