Bilaterally Reduced Intraepidermal Nerve Fiber Density in Unilateral CRPS-I

Vinni F Rasmussen1, Páll Karlsson1,2, Peter D Drummond3

  • 1Danish Pain Research Center, Aarhus University Hospital, Aarhus, Denmark.

Abstract

Related Concept Videos

Local Anesthetics: Differential Sensitivity of Nerve Fibers01:24

Local Anesthetics: Differential Sensitivity of Nerve Fibers

Local anesthetics (LAs) block the sodium channels of nerve trunks, sensory nerve endings, and neuromuscular junctions. Although LAs can block all kinds of nerves, the sensitivity of nerve fibers differs according to nerve types and structures. LAs are known to block myelinated fibers faster than unmyelinated ones. Also, they block pain or sensory neurons at low concentrations without affecting the motor neurons involved in muscle contractions. This helps relieve labor pain without affecting the...
1.4K
Reducing Line Loss01:18

Reducing Line Loss

In a three-phase circuit, line loss is an indicator of energy dissipated as heat due to the resistance of transmission lines. To address this, incorporating transformers into the system—a step-up transformer at the source and a step-down transformer at the load—is a strategic solution. Two three-phase transformers are introduced to improve this.
With a step-up transformer at the source, the voltage is increased, thereby reducing the current in the transmission lines since power loss in...
390
Classification of Skeletal Muscle Fibers01:48

Classification of Skeletal Muscle Fibers

Skeletal muscles continuously produce ATP to provide the energy that enables muscle contractions. Skeletal muscle fibers can be categorized into three types based on differences in their contraction speed and how they produce ATP, as well as physical differences related to these factors. Most human muscles contain all three muscle fiber types, albeit in varying proportions.
Slow-Twitch Muscle Fibers
Slow oxidative, muscle fibers appear red due to large numbers of capillaries and high levels of...
59.5K
Density00:56

Density

Density is an important characteristic of substances, crucial in determining whether an object sinks or floats in a fluid. Its SI unit is kg/m3, and its cgs unit is g/cm3. The density of an object helps in identifying its composition, and also reveals information about the phase of the matter and its substructure. The densities of liquids and solids are roughly comparable, consistent with the fact that their atoms are in close contact. However, gases have much lower densities than liquids and...
19.9K
Current Density01:21

Current Density

The total amount of current flowing through one unit value of a cross-sectional area is referred to as current density. If the current flow is uniform, the amount of current flowing through a conductor is the same at all points along the conductor, even if the conductor area varies. The current density consists of the local magnitude and direction of the charge flow, which varies from point to point. Current density is measured in amperes per meter square, and direction is defined as the net...
5.1K
Methods of reducing fever01:22

Methods of reducing fever

The signs and symptoms of fever include hot and dry skin, flushed face, thirst, muscle aches, anorexia, headache, tachycardia, tachypnea, and fatigue. Elevated body temperature is reduced using two methods: pharmacological and nonpharmacological. Proper identification and treatment of the root cause of a fever is of utmost importance.
Pharmacological Methods of Reducing Fever:
1.4K