Racial and Sociodemographic Differences of Semen Parameters Among US Men Undergoing a Semen Analysis

Clara Helene Glazer1, Shufeng Li2, Chiyuan Amy Zhang2

  • 1Department of Urology, Stanford University School of Medicine, Stanford, CA; Department of Occupational and Environmental Medicine, Bispebjerg University Hospital, Copenhagen, Denmark.

Urology
|October 10, 2018
PubMed
Abstract

Related Concept Videos

Sperm Structure and Semen Composition01:22

Sperm Structure and Semen Composition

During ejaculation, males release around 2-5 milliliters of semen, which is a complex mixture of mature sperm and various fluids produced by accessory glands. The mature sperm cells measure approximately 60 micrometers in length and consist of a head, neck, midpiece, and tail. The head is flattened and tapered, measuring about 4 to 5 micrometers in length. It contains a nucleus with condensed chromosomes and an acrosome, a cap-like structure filled with enzymes essential for penetrating the...
11.2K
Noncompartmental Analysis: Miscellaneous Pharmacokinetic Parameters00:54

Noncompartmental Analysis: Miscellaneous Pharmacokinetic Parameters

The noncompartmental approach is a widely used method in pharmacokinetics to assess drugs' behaviors in the body. It considers several factors, including clearance, bioavailability, and total volume of distribution.
One key aspect of the noncompartmental approach is determining a drug's total clearance. This can be done by dividing the drug dose by the area under the concentration-time curve from zero to infinity. The area under the concentration-time curve represents the drug's...
452
Electric Potential and Potential Difference01:16

Electric Potential and Potential Difference

Suppose a positive test charge moves away from a positive static charge, then the Coulomb force does positive work, and its electric potential energy decreases. The potential energy per unit charge is defined as the electric potential. The electric potential is independent of the test charge.
When a test charge moves from the initial to the final position, the electric potential difference between those positions is defined as the ratio of the change in the potential energy to the charge on the...
5.7K
Difference from Background: Limit of Detection01:05

Difference from Background: Limit of Detection

The limit of detection (LOD) is the smallest amount of analyte that can be distinguished from the background noise. The LOD value corresponds to the concentration at which the analyte signal is three times larger than the standard deviation of the blank signal. Below this value, the analyte signal cannot be differentiated from the background noise. It is calculated by dividing the calibration slope by 3 times the standard deviation of the blank signals.
The LOD indicates the presence or absence...
8.3K
Wave Parameters01:10

Wave Parameters

The simplest mechanical waves are associated with simple harmonic motion and repeat themselves for several cycles. These simple harmonic waves can be modeled using a combination of sine and cosine functions. Consider a simplified surface water wave that moves across the water's surface. Unlike complex ocean waves, in surface water waves, water moves vertically, oscillating up and down, whereas the disturbance of the wave moves horizontally through the medium. If a seagull is floating on the...
9.3K
Identifying Statistically Significant Differences: The F-Test01:14

Identifying Statistically Significant Differences: The F-Test

The F-test is used to compare two sample variances to each other or compare the sample variance to the population variance. It is used to decide whether an indeterminate error can explain the difference in their values. The underlying assumptions that allow the use of the F-test include the data set or sets are normally distributed, and the data sets are independent of each other. The test statistic F is calculated by dividing one variance by another. In other words, the square of one standard...
3.8K