Comprehensive performance evaluation of LID practices for the sponge city construction: A case study in Guangxi,

Qian Li1, Feng Wang1, Yang Yu2

  • 1Graduate School at Shenzhen, Tsinghua University, Shenzhen, 518055, PR China; Guangdong Provincial Engineering Technology Research Center for Urban Water Cycle and Water Environment Safety, Shenzhen, 518055, PR China; State Environmental Protection Key Laboratory of Microorganism Application and Risk Control, School of Environment, Tsinghua University, Beijing, 10084, PR China.

Related Concept Videos

Characteristics of Practical Op Amps01:16

Characteristics of Practical Op Amps

A difference amplifier, a crucial component in numerous electronic devices, ideally amplifies only the difference-mode signal, which is the difference between two input signals. However, in practical circuits, the output voltage depends on both the differential gain and the common-mode gain.
The ratio of differential gain to the common-mode gain is defined as the common-mode rejection ratio (CMRR). This ratio quantifies the ability of operational amplifiers (op-amps) to reject common-mode...
864
Theoretical Foundations of Nursing Practice01:30

Theoretical Foundations of Nursing Practice

Theories play an essential role in organizing patient care. Theories refer to a proposed or followed belief, policy, or procedure that is the basis for action. Nursing theories are knowledge-based concepts that guide nurses' actions, influence nursing education and practice, and allow nurses to care for their patients.
Theories provide a perspective to assess patients' conditions and organize data and methods. They also assist in analyzing and interpreting information. They represent a...
17.4K
Equivalent Circuits for Practical Transformers01:28

Equivalent Circuits for Practical Transformers

The practical equivalent circuits of single-phase two-winding transformers exhibit significant deviations from their idealized versions due to the inherent properties of winding resistance and finite core permeability. These properties result in real and reactive power losses, affecting the transformer's performance. Understanding these deviations is crucial for designing more efficient transformers.
In a practical transformer, each winding exhibits resistance and leakage reactance. The...
1.4K
Construction of Root Locus01:15

Construction of Root Locus

The construction of a root locus involves several key steps to analyze and visualize the behavior of a system's poles with varying gain. The number of branches in the root locus equals the number of closed-loop poles and is symmetrical about the real axis.
For positive gain values, the root locus exists on the real axis to the left of an odd number of finite open-loop poles or zeros. The root locus starts at the open-loop poles and traces the paths of the closed-loop poles as the gain...
418
Construction of Frequency Distribution01:15

Construction of Frequency Distribution

A frequency distribution table can be constructed using the steps given below.
First, make a table with two columns—one with the title of the data that needs to be organized, and the other column for frequency. [Draw a third column for tally marks if needed]. Then, take a look at the items given in the data set and decide if an ungrouped frequency distribution table or a grouped frequency distribution table would be more suitable. If there are large sets of different values, then it is...
12.8K
Bode Plots Construction01:24

Bode Plots Construction

The Bode plot is an essential tool in control system analysis, mapping the frequency response of a system through a magnitude plot and a phase plot, both against a logarithmic frequency axis. To construct a Bode plot, consider the transfer function H(ω):
1.1K