Related Experiment Video

Updated: Feb 3, 2026

Tracking Individual Running Metrics in Mice Using a Voluntary Wheel Running Protocol that Minimizes Social Isolation
04:48

Tracking Individual Running Metrics in Mice Using a Voluntary Wheel Running Protocol that Minimizes Social Isolation

Published on: April 18, 2025

1.1K

Designing and Running a Preoperative Clinic

Jeanna D Blitz1, Christian Mabry2

  • 1Preadmission Testing, Department of Anesthesiology, Perioperative Care and Pain Medicine, NYU School of Medicine, 550 1st Avenue, TH 552, New York, NY 10016, USA.

Anesthesiology Clinics
|November 5, 2018
PubMed

Keywords:
Advanced practice providersPreoperative evaluationQuality improvementResident educationTriple-aim frameworkValue in health care

More Related Videos

Influence of Step-Width Manipulation on Running Biomechanics06:53

Influence of Step-Width Manipulation on Running Biomechanics

Published on: February 28, 2025

1.0K
Subretinal Implantation of RPE on a Carrier in Minipigs: Guidelines for Preoperative Preparations, Surgical Techniques, and Postoperative Care11:06

Subretinal Implantation of RPE on a Carrier in Minipigs: Guidelines for Preoperative Preparations, Surgical Techniques, and Postoperative Care

Published on: November 11, 2022

3.3K

Related Concept Videos

Wald-Wolfowitz Runs Test II01:17

Wald-Wolfowitz Runs Test II

The Wald-Wolfowitz runs test, commonly referred to as the runs test, is a nonparametric test used to assess the randomness of ordered data. The test evaluates the number of runs, which are consecutive sequences of similar elements within the data. If the number of runs is significantly higher or lower than expected, the data is considered non-random, indicating a detectable pattern or structure.
For binary data, runs are identified using symbols such as + and −, or equivalently, 1s and 0s. In...
551
Wald-Wolfowitz Runs Test I01:17

Wald-Wolfowitz Runs Test I

The Wald-Wolfowitz test, also known as the runs test, is a nonparametric statistical test used to assess the randomness of a sequence of two different types of elements (e.g., positive/negative values, successes/failures). It examines whether the order of the elements in a sequence is random or if there is a pattern or trend present. This nonparametric test applies to any ordered data despite the population and sample data distribution, even if a higher sample size is available.
The test works...
961
Group Design02:01

Group Design

The most basic experimental design involves two groups: the experimental group and the control group. The two groups are designed to be the same except for one difference— experimental manipulation. The experimental group gets the experimental manipulation—that is, the treatment or variable being tested—and the control group does not. Since experimental manipulation is the only difference between the experimental and control groups, we can be sure that any differences between...
10.5K
Factorial Design02:01

Factorial Design

Factorial Analysis is an experimental design that applies Analysis of Variance (ANOVA) statistical procedures to examine a change in a dependent variable due to more than one independent variable, also known as factors. Changes in worker productivity can be reasoned, for example, to be influenced by salary and other conditions, such as skill level. One way to test this hypothesis is by categorizing salary into three levels (low, moderate, and high) and skills sets into two levels (entry level...
13.8K
Design Example: Designing a Residential Plumbing System01:25

Design Example: Designing a Residential Plumbing System

The design of residential plumbing systems requires carefully evaluating water demand, flow rates, and pressure dynamics to ensure both efficiency and reliability. The nature of water flow within pipes is defined by its Reynolds number, which classifies flow as either laminar (smooth) or turbulent.
1.1K
Design Example: Designing Water Slide01:18

Design Example: Designing Water Slide

When designing a water slide, controlling the speed of water flow is crucial for rider safety while maintaining an exciting experience. As water flows down the slide, gravity causes it to accelerate, with its speed at the bottom depending on the height from which it starts. The higher the slide, the more potential energy the water has at the top, which is converted into kinetic energy as it descends, increasing its speed.
Bernoulli's principle determines the water's velocity along the slide....
629