Related Experiment Video
Updated: Feb 1, 2026
Two-Dimensional X-Ray Angiography to Examine Fine Vascular Structure Using a Silicone Rubber Injection Compound
Published on: January 7, 2019
Relationship between Injection Rate and Contrast Enhancement on Three-dimensional Digital Subtraction Angiography of
Satoshi Takagi1, Naoyuki Hanasaki2
1Hokkaido University, JP.
Objective:
Three-dimensional (3D) digital subtraction angiography (DSA) is becoming a common technique for the assessment of the cerebral arteries. Nevertheless, the injection parameters for each artery are not standardized among institutions. The objective of this study was to analyze the relationship between injection rate and contrast enhancement on 3D DSA of the common carotid artery.
Materials And Methods:
Twenty-four patients who underwent 3D DSA of the common carotid artery from June 2013 to March 2015 were included in this retrospective study. Contrast enhancement of each patient was analyzed for four cerebral arteries segments (A1, A2, M1 and M2) by measuring the average pixel value on the source rotational two-dimensional DSA images. Linear regression analysis was used to investigate the correlation between injection rate and contrast enhancement.
Results:
All four regression lines showed that a higher injection rate led to higher contrast enhancement. There was a significant relationship for the A1, A2 and M1 segments (P = 0.008, 0.03 and < 0.001) but not for the M2 segment (P = 0.13). The goodness-of-fit of the regression lines was high for the M1 segment (R2 = 0.63). However, as the size of the vascular lumen became narrower, the value for the A1 (R2 = 0.28) and A2 (R2 = 0.19) segments became lower.
Conclusion:
In 3D DSA of the common carotid artery, contrast enhancement of a relatively wide lumen could be optimized by adjusting the injection rate. However, it is difficult to optimize the contrast enhancement of a relatively narrow lumen only by adjusting the injection rate.
Related Concept Videos
02:12Relationship Formation
03:03Concentration and Rate Law
For example, in a generic reaction aA + bB ⟶ products, where a and b are stoichiometric coefficients, the rate law can be written as:
01:28Ending Relationships
03:08Rate-Determining Steps
In a multistep reaction mechanism, one of the elementary steps progresses significantly slower than the others. This slowest step is called the rate-limiting step (or rate-determining step). A reaction cannot proceed faster than its slowest step, and hence, the rate-determining step limits the overall reaction rate.
The concept of rate-determining step can be understood from the analogy of a 4-lane freeway with a short-stretch of traffic-bottleneck caused due to...
02:55Temperature Dependence on Reaction Rate
Atoms, molecules, or ions must collide before they can react with each other. Atoms must be close together to form chemical bonds. This premise is the basis for a theory that explains many observations regarding chemical kinetics, including factors affecting reaction rates.
The collision theory is based on the postulates that (i) the reaction rate is proportional to the rate of reactant collisions, (ii) the reacting species collide in an orientation allowing contact between...
01:26Phase Contrast and Differential Interference Contrast Microscopy
In-phase-contrast microscopes, interference between light directly passing through a cell and light refracted by cellular components is used to create high-contrast, high-resolution images without staining. It is the oldest and simplest type of microscope that creates an image by altering the wavelengths of light rays passing through the specimen. Altered wavelength paths are created using an annular stop in the condenser. The annular stop produces a hollow cone of...