Combined 5-minute double-echo in steady-state with separated echoes and 2-minute proton-density-weighted 2D FSE

Akshay S Chaudhari1,2, Kathryn J Stevens1,3, Bragi Sveinsson1,4,5

  • 1Department of Radiology, Stanford University, Stanford, California, USA.

Abstract

Related Concept Videos

Echo01:06

Echo

The human ear cannot distinguish between two sources of sound if they happen to reach within a specific time interval, typically 0.1 seconds apart. More than this, and they are perceived as separate sources.
Imagine the sound is reflected back to the ears. Assuming that the source is very close to the human, the difference between hearing the two sounds—the emitted sound and the reflected sound—may be more than the minimum time for perceiving distinct sounds. If this is the case,...
956
Knee Joint01:23

Knee Joint

The knee joint is the most complicated joint in the body. It consists of three articulations– two tibiofemoral and one patellofemoral. As is characteristic of synovial joints, the knee joint has a thin articular capsule that partially surrounds this joint cavity. Additionally, several ligaments, muscles, and cartilaginous structures support the movement of the knee.
A total of seven ligaments support the knee joint. The patellar ligament, which is also attached to the quadriceps femoris...
3.2K
Types of Building Separation Joints01:23

Types of Building Separation Joints

Building separation joints divide large or complex building structures into smaller, discrete units that can move independently. These joints are categorized into three types: volume-change joints, settlement joints, and seismic separation joints.
Volume-change joints address the effects of expansion and contraction due to temperature and moisture variations. They are strategically placed at discontinuities in a building's mass where cracking is most likely and are spaced about 150 to 200...
607
Density, Specific Weight, Specific Gravity and Compressibility of Fluid01:27

Density, Specific Weight, Specific Gravity and Compressibility of Fluid

Density, specific weight, specific gravity, and compressibility are fundamental properties of fluids. Density is the mass per unit volume, characterizing the mass of a fluid system. It influences buoyancy, pressure, flow dynamics, viscosity, thermal conductivity, and sound propagation. For instance, in pipeline design, accurate density measurements ensure that the pipeline can handle the fluid's mass.
Specific weight represents the weight per unit volume and is calculated by multiplying...
1.6K
Steady State Concentration01:05

Steady State Concentration

A steady state refers to the level of a drug in the body once it has reached an equilibrium between administration and elimination. It represents the point at which the drug administration rate equals the drug elimination rate, resulting in a relatively constant concentration in the body over time. The dynamic equilibrium is crucial to ensure the drug's effectiveness with minimal risk of toxicity.
Most drugs are administered in repeated doses at fixed intervals or through continuous...
6.0K
Structural Joints: Synovial Joints01:16

Structural Joints: Synovial Joints

Synovial joints are the most common type of joint in the body. A key structural characteristic for a synovial joint is the presence of a joint cavity. This fluid-filled space is where the articulating surfaces of the bones contact each other. Also, unlike fibrous or cartilaginous joints, the articulating bone surfaces at a synovial joint are not directly connected to each other with fibrous connective tissue or cartilage. This gives the bones of a synovial joint the ability to move smoothly...
6.8K