Indocyanine green dye angiography as an adjunct to assess indeterminate burn wounds: A prospective, multicentered,

Apinut Wongkietkachorn1, Palakorn Surakunprapha, Kengkart Winaikosol

  • 1From the Division of Plastic and Reconstructive Surgery, Department of Surgery (A.W.), Faculty of Medicine, Mae Fah Luang University, Chiang Rai; Division of Plastic and Reconstructive Surgery, Department of Surgery (P.S., K.W., P.P., K.J., B.C.), Department of Pathology, Faculty of Medicine (S.W., S.C.), Khon Kaen University; Division of Plastic and Reconstructive Surgery, Department of Surgery (K.E.), Khon Kaen Hospital, Khon Kaen; and Division of Plastic and Reconstructive Surgery, Department of Surgery (N.W.), Q Clinic, Bangkok, Thailand.

Abstract

Related Concept Videos

Blind Procedures02:07

Blind Procedures

Ideally, the people who observe and record the children’s behavior are unaware of who was assigned to the experimental or control group, in order to control for experimenter bias. Experimenter bias refers to the possibility that a researcher’s expectations might skew the results of the study. Remember, conducting an experiment requires a lot of planning, and the people involved in the research project have a vested interest in supporting their hypotheses. If the observers knew which...
13.4K
Indeterminate Structure01:18

Indeterminate Structure

Indeterminate structures refer to structures where internal forces and reactions cannot be determined using only the equations of static equilibrium.  Indeterminate structures have more unknown forces and reaction forces than equations of static equilibrium that can be used to determine them. Indeterminate structures are often used in engineering to create complex, efficient, and aesthetically pleasing structures. There are various types of indeterminate structures used in engineering and...
1.5K
Indeterminate Products01:29

Indeterminate Products

Indeterminate forms also arise in the evaluation of limits involving products, particularly when one factor approaches zero while the other tends to positive or negative infinity. This situation, commonly described as a zero-times-infinity form, does not have an immediately interpretable outcome. Depending on how the factors behave relative to one another, the limit of such a product may be zero, infinite, or a finite nonzero value.Product Limits and Algebraic RewritingTo analyze limits of this...
52
Blinding01:11

Blinding

Blinding is a commonly used method of not telling participants which treatment a subject is receiving. Blinding is a critical part of a randomized control trial or RCT. It reduces the bias that affects the results. In an RCT, blinding is used in the form of a placebo. A placebo effect occurs when untreated subjects falsely believe they have received the treatment and report improved symptoms. A placebo or a dummy treatment is administered to subjects to negate the bias caused by such an effect.
4.0K
Statically Indeterminate Problem Solving01:16

Statically Indeterminate Problem Solving

Statically indeterminate problems are those where statics alone can not determine the internal forces or reactions. Consider a structure comprising two cylindrical rods made of steel and brass. These rods are joined at point B and restrained by rigid supports at points A and C. Now, the reactions at points A and C and the deflection at point B are to be determined. This rod structure is classified as statically indeterminate as the structure has more supports than are necessary for maintaining...
722
Burn Injuries01:22

Burn Injuries

Burn injuries occur when the skin and underlying tissues are damaged due to exposure to heat, electricity, chemicals, radiation, or friction. They can vary in severity, from minor superficial burns to severe deep burns that can be life-threatening.
The damage results in the death of skin cells, which can lead to a massive loss of fluid. Dehydration, electrolyte imbalance, and renal and circulatory failure follow, which can be fatal. Burn patients are treated with intravenous fluids to offset...
4.4K