Related Experiment Video
Updated: Jan 31, 2026

Systematic Hearing Performance Evaluation Process for Adolescents with Cochlear Implantation at Early Ages
Published on: March 24, 2023
Age-dependent variations of scalp thickness in the area designated for a cochlear implant receiver stimulator
Omer J Ungar1, Uri Amit1, Oren Cavel1
1Department of Otolaryngology Head, Neck and Maxillofacial Surgery, Tel-Aviv Sourasky Medical Center, Sackler School of Medicine Tel-Aviv University Tel-Aviv Israel.
Objective:
The integrity of the scalp overlying a cochlear implant receiver stimulator (RS) is critical for the long-term survival of the implant. Exposure or extrusion of the device will likely result in the need for its removal. There is a global trend of acceleration of population aging, thus raising the prevalence of cochlear implantation (CI) in the elderly. The aim of this study was to define age-dependent changes in scalp thickness and discuss the implication of that anatomical characteristic for CI in the geriatric population.
Methods:
Scalp thickness over the location of the RS in the temporo-parietal area was measured directly with a needle in patients of various ages.
Results:
Two-hundred thirty-six temporo-parietal scalps were measured in patients aged 18 to 85 years. A strong inverse correlation was found between age and scalp thickness (rs = -0.723, P < .001). Scalp thickness decreased with age from a mean of 8 mm in the third decade of life to 5 mm in the ninth decade of life.
Conclusion:
The human scalp thins with age and most likely undergoes a reduction in its strength. As a consequence, implantable hearing devices that are shielded by the scalp can be at increased risk of exposure and extrusion in the aging recipient. This needs to be taken into account when considering an implantation procedure, the surgical approach and patient instructions on need for and venues for continuing care over time.
Level Of Evidence:
2B.
Related Concept Videos
Design Example: Deciding Thickness of Lubricating Fluid in a Shaft
To calculate the required thickness of the lubricant layer, the tangential velocity at the shaft's surface must first be determined. This velocity is calculated by converting the rotational speed to angular velocity...
What is Variation?
The range, standard deviation, standard error, and variance are the different measures of variation.
Range: The range is the difference between its maximum and...
Conservative Site-specific Recombination and Phase Variation
The recognition sites for Cre recombinase called LoxP...
Variation
When independent and dependent variables are plotted on a scatter plot, the slope of a line is a value that describes the rate of change between the two...
Group Design
Receiver Operating Characteristic Plot

