Related Experiment Video
Updated: Jan 29, 2026
Cone Beam Intraoperative Computed Tomography-based Image Guidance for Minimally Invasive Transforaminal Interbody Fusion
Published on: August 6, 2019
Comparison between two bone substitutes for alveolar ridge preservation after tooth extraction: Cone-beam computed
Alexandre Hugo Llanos1, Vítor Marques Sapata1, Ronald E Jung2
1Discipline of Periodontics, School of Dentistry, University of São Paulo, São Paulo, Brazil.
Aim:
To test the non-inferiority of demineralized bovine bone mineral (DBBM) compared to DBBM with 10% collagen (DBBM-C) for maintenance of bone volume after tooth extraction in the anterior maxilla.
Materials And Methods:
Sixty-six patients were randomly treated with DBBM or DBBM-C, both of which were covered with a collagen matrix for ridge preservation in the anterior maxilla. Cone-beam computed tomographic analysis was performed immediately and 4 months after treatment. The primary outcome, for which non-inferiority of DBBM was tested, was change in the horizontal ridge width 1 mm below the buccal alveolar crest (HW-1) 4 months after extraction.
Results:
Four months after extraction, HW-1 measured -1.60 mm ± 0.82 mm for DBBM-C, while the DBBM group showed a mean loss of -1.37 mm ± 0.84 mm (p = 0.28, 0.23 [95% CI: -0.19; 0.64]). The horizontal ridge width at 3 mm (HW-3) showed -0.98 mm (±0.67 mm) for DBBM-C and -0.84 mm (±0.62 mm) for DBBM (p = 0.40, 0.12 [95% CI: -0.19; 0.45]), and the horizontal ridge width at 5 mm (HW-5) showed -0.67 mm (±0.47 mm) for DBBM-C and -0.56 mm (±0.48 mm) for DBBM (p = 0.36, 0.11 [95% CI: -0.13; 0.34]).
Conclusions:
The present clinical trial demonstrated non-inferiority of DBBM compared to DBBM-C for maintenance of alveolar bone volume 4 months after tooth extraction in the anterior maxilla.
More Related Videos
10:24Neutron Radiography and Computed Tomography of Biological Systems at the Oak Ridge National Laboratory's High Flux Isotope Reactor
Published on: May 7, 2021
10:23Author Spotlight: Three-Dimensional Cephalometric Landmark Annotation Demonstration on Human Cone Beam Computed Tomography Scans
Published on: September 8, 2023
Related Concept Videos
01:10Computed Tomography
The technique was invented in the 1970s and is based on the principle that as X-rays pass through the body, they are absorbed or reflected at different levels. In the technique, a patient lies on a motorized platform while a computerized axial tomography (CAT) scanner rotates...
01:27Imaging Studies III: Computed Tomography
01:21Tooth Anatomy
The Crown, Neck, and Root
The visible part of the tooth is referred to as the crown. It's covered by enamel, the hardest substance in the human body. The crown is uniquely shaped for each type of tooth, allowing for different functions such as cutting, tearing, or...
01:30Beams
Based on geometry, beams can be straight, tapered, or curved. Straight beams are the most common type and have a constant cross-section throughout their length. Tapered beams, on the other hand, have a varying cross-section along...
01:26Alveoli and Alveolar Ducts
01:11Clinical Trials: Overview