Stronger responses in the visual cortex of sighted compared to blind individuals during auditory space representation

Claudio Campus1,2, Giulio Sandini2, Maria Bianca Amadeo1,3

  • 1U-VIP Unit for Visually Impaired People, Fondazione Istituto Italiano di Tecnologia, Via Morego 30, 16132, Genova, Italy.

Scientific Reports
|February 15, 2019
PubMed

Related Concept Videos

State Space Representation01:27

State Space Representation

The frequency-domain technique, commonly used in analyzing and designing feedback control systems, is effective for linear, time-invariant systems. However, it falls short when dealing with nonlinear, time-varying, and multiple-input multiple-output systems. The time-domain or state-space approach addresses these limitations by utilizing state variables to construct simultaneous, first-order differential equations, known as state equations, for an nth-order system.
Consider an RLC circuit, a...
558
Blind Procedures02:07

Blind Procedures

Ideally, the people who observe and record the children’s behavior are unaware of who was assigned to the experimental or control group, in order to control for experimenter bias. Experimenter bias refers to the possibility that a researcher’s expectations might skew the results of the study. Remember, conducting an experiment requires a lot of planning, and the people involved in the research project have a vested interest in supporting their hypotheses. If the observers knew which...
13.4K
Blinding01:11

Blinding

Blinding is a commonly used method of not telling participants which treatment a subject is receiving. Blinding is a critical part of a randomized control trial or RCT. It reduces the bias that affects the results. In an RCT, blinding is used in the form of a placebo. A placebo effect occurs when untreated subjects falsely believe they have received the treatment and report improved symptoms. A placebo or a dummy treatment is administered to subjects to negate the bias caused by such an effect.
3.9K
Sight Distance in a Vertical Curve01:29

Sight Distance in a Vertical Curve

Sight distance on vertical curves is critical in roadway design. It ensures drivers can see far enough ahead to identify and respond to hazards effectively. This directly impacts safety, driver comfort, and the overall efficiency of the transportation network.Vertical curves are classified into crest and sag curves based on their geometry. For crest curves, sight distance is determined by the line of sight between a driver's eye and a small object on the road's surface. Design parameters for...
364
Control Volume and System Representations01:16

Control Volume and System Representations

Two key frameworks are employed to analyze mass, energy, and momentum transfer: the control volume approach and the system approach. These frameworks offer different perspectives, depending on whether the focus is on a specific region in space (control volume approach) or a defined mass of fluid (system approach).
The control volume approach considers a stationary region in space through which fluid flows. This region is bounded by a control surface.  For instance, in the case of water...
1.5K
Graphical Representation of Inequalities01:28

Graphical Representation of Inequalities

The graph of the equation where y equals x squared forms a curve known as a parabola. This curve acts as a boundary in the coordinate plane, dividing it into distinct regions based on the relative position of points.When the equality sign in the equation is replaced with an inequality—such as greater than, less than, greater than or equal to, or less than or equal to—the graphical representation changes from a single curve into a broader shaded area that signifies the set of all...
200