Related Experiment Video
Updated: Jan 28, 2026
'Boden Food Plate': Novel Interactive Web-based Method for the Assessment of Dietary Intake
Published on: September 18, 2018
Comparison and optimization of three commercial methods with an LC-MS/MS method for the determination of sulfites in
Katherine S Carlos1, Mascha Treblin1, Lowri S de Jager1
1Center for Food Safety and Applied Nutrition, U.S. Food and Drug Administration, 5001 Campus Drive, HFS 706, College Park, MD 20740, United States.
Abstract:
Sulfites are food additives found in a large variety of food products to help reduce oxidation and browning. A small subset of the population has "allergic-like" symptoms upon consumption of sulfite containing foods. There are several sulfite detection methods available in the literature that vary in analysis time and required instrumentation. There are also rapid screening tests available that have not been tested extensively for accuracy and precision. In this study, four different methods (an LC-MS/MS method, a spectrophotometric method, a test strip method and a spot test method) were used to determine the sulfite concentration of 10 different commercially sulfited products. Of these methods, the LC-MS/MS and the spectrophotometric method had the most comparable results. The test strips were only accurate at concentrations greater than 50 mg/kg (ppm) SO2. The spot test method was found to be inaccurate with both standard solutions and samples.
More Related Videos
12:35Comparison of Three Different Methods for Determining Cell Proliferation in Breast Cancer Cell Lines
Published on: September 3, 2016
08:21Optimized Procedure for Determining the Adsorption of Phosphonates onto Granular Ferric Hydroxide using a Miniaturized Phosphorus Determination Method
Published on: May 18, 2018
Related Concept Videos
01:08Renal Drug Clearance: Comparison Between Renal Excretion Methods
Renal clearance is often associated with the renal glomerular filtration rate (GFR), which represents the rate at which plasma is filtered through the glomeruli in the kidney. When drug reabsorption is minimal and there is no active secretion, renal clearance is closely related to the...
01:22Protein-Drug Binding: Determination Methods
Indirect methods involve isolating the bound drug from its free form in biological samples such as blood, serum, or plasma. These techniques aim to measure the percentage of drugs bound to proteins. Equilibrium dialysis is a commonly used method where the free drug concentration at equilibrium is measured by separating the bound...
01:21Dose Size and Dosing Frequency: Determination Methods
01:19Dosage Interval and Administration Route: Determination Methods
01:07Determination of Renal Drug Clearance: Graphical and Midpoint Methods
The graphical method involves plotting the rate of drug excretion in urine against the plasma drug concentration. By analyzing the graph, the clearance can be calculated and obtained. Drugs rapidly excreted by the kidneys exhibit a...
01:29Methods of Sterilization I: Physical Methods
Steam sterilization uses non-toxic, low-cost moist heat in the form of saturated steam under pressure, which is fast, microbicidal, and sporicidal, and quickly warms and penetrates fabrics. Autoclaves, or steam sterilizers, expose each item to direct steam contact for a predetermined time at the necessary...