Related Experiment Video
Updated: Jan 28, 2026

A Coregistered Ultrasound and Photoacoustic Imaging Protocol for the Transvaginal Imaging of Ovarian Lesions
Published on: March 3, 2023
De-noising of photoacoustic sensing and imaging based on combined empirical mode decomposition and independent
Meng Zhou1,2, Huangxuan Zhao3,4, Haibo Xia2
1Hybrid Imaging System Laboratory, School of Information Science and Technology, ShanghaiTech University, Shanghai, China.
Abstract:
Photoacoustic (PA) imaging breaks the diffusion limit of conventional optical imaging by listening to the PA wave. As a new kind of functional imaging method, it has experienced tremendous growth in research community with wide range of applications. However, it is still an open and fundamental challenge that the conversion efficiency from light to sound based on PA effect is extremely low. The consequence is the poor signal-to-noise ratio (SNR) of PA signal especially in scenarios of low laser power and deep penetration. Conventional approach to enhance the SNR of PA signal in these noisy scenarios is data averaging, which is quite time-consuming. To improve the signal fidelity and imaging speed, an algorithm of using empirical mode decomposition and independent component analysis de-noising methods in PA imaging is proposed. The simulation and in vivo experimental results show obvious SNR enhancement of the PA signal and image contrast. The proposed method provides the potential to develop real-time low-cost PA imaging system with low-power laser source.
More Related Videos
Related Concept Videos
Synthesis and Decomposition Reactions
Introduction to Test of Independence
The test statistic for a test of independence is similar to that of a goodness-of-fit test:
Hypothesis Test for Test of Independence
H0: The two variables (factors)...
Empirical Method to Interpret Standard Deviation
This rule is used widely in statistics to calculate the proportion of data values...
The Sense of Self: Reflected Self-Appraisal and Social Comparison
What is a Mode?
There can be more than one mode in a data set if multiple values have the same highest frequency. For instance, suppose that the Statistics exam scores of 20 students are: 50; 53; 59; 59; 63; 63; 72; 72; 72; 72; 72; 76; 78; 81; 83; 84; 84; 84; 90; 93. Here, the mode is 72, as it occurs most frequently, five times.
A data set with two modes is called bimodal. For example,...

