Fluoranthene Biodegradation by Serratia sp. AC-11 Immobilized into Chitosan Beads

A C F S Garcia1, B R Araújo1, W G Birolli2

  • 1Laboratory of Natural Organic Matter, Department of Chemistry, Federal University of Sergipe, Av. Marechal Rondon, Jardim Rosa Elze, Sao Cristovao, SE, 49100-000, Brazil.

Related Concept Videos

AC Sources01:20

AC Sources

Direct current is a flow of electric charge in only one direction and has a steady state of constant voltage in the circuit. Rectifiers, batteries, commutator-equipped generators, and fuel cells are some examples of devices that generate direct current. Nowadays, most applications use a time-varying voltage source. Alternating current is a flow of electric charge that periodically reverses direction. An alternating current is produced by an alternating emf that is generated in a power plant. If...
4.1K
Resistor in an AC Circuit01:31

Resistor in an AC Circuit

An alternating emf or voltage source is needed to supply an alternating current (AC) to a circuit. A coil of wire rotating in a magnetic field at a constant angular speed represents such a source. It also generates a sinusoidal alternating emf and serves as an industrial alternator.
One-way current through the meter is measured using diodes. A diode is a device with better conductivity in one direction compared to the other; in its ideal state, it has zero resistance in one direction and allows...
3.2K
Power in an AC Circuit01:26

Power in an AC Circuit

In a DC circuit, the power consumed is simply the product of the DC voltage times the DC current, given in watts. However, the power consumed for AC circuits with reactive components is calculated differently. Since electrical power is the "rate" at which energy is used in a circuit, all electrical and electronic components and devices have a safe operating range for electrical power.
In a DC circuit, there is no sinusoidal waveform associated with the supply; the voltages and currents are...
2.3K
Conservation of AC Power01:15

Conservation of AC Power

The principle of power preservation is applicable to both ac and dc circuits. This principle, when applied to AC power, asserts that the complex, real, and reactive powers produced by the source are equal to the total complex, real, and reactive powers absorbed by the loads. When two load impedances are connected in parallel to an ac source V, the complex power provided by the source can be calculated using the relation
677
Capacitor in an AC Circuit01:23

Capacitor in an AC Circuit

A capacitor is charged by passing an electric current through it, which causes the plates to start accumulating an electrostatic charge. Since the strength of the charging current is maximum when the capacitor plates are uncharged and gradually decreases exponentially until the capacitor is fully charged, the charging process is neither instantaneous nor linear. The property of a capacitor to store a charge on its plates is called its capacitance.
Consider a purely capacitive circuit consisting...
3.7K
Inductor in an AC Circuit01:16

Inductor in an AC Circuit

The basic components of an inductor are coils or loops of wire that are either wound around a hollow tube former or a ferromagnetic material (iron-cored) to increase their inductive value or inductance. When a voltage is applied across an inductor's terminals, a magnetic field is created, where the inductor stores its energy. The inductor's own self-induced or back emf value controls the growth of the current flowing through it.  This back emf voltage is proportional to the rate of...
2.9K