Determination of Haematological Reference Ranges in Healthy Adults in Three Regions in Ghana

Otchere Addai-Mensah1, Daniel Gyamfi2, Richard Vikpebah Duneeh3

  • 1Faculty of Allied Health Sciences, Kwame Nkrumah University of Science and Technology, Kumasi, Ghana.

Laboratory results interpretation for diagnostic accuracy and clinical decision-making in this period of evidence-based medicine requires cut-off values or reference ranges that are reflective of the geographical area where the individual resides. Several studies have shown significant differences between and within populations, emphasizing the need for population-specific reference ranges. This cross-sectional experimental study sought to establish the haematological reference values in apparently healthy individuals in three regions in Ghana. Study sites included Nkenkaasu, Winneba, and Nadowli in the Ashanti, Central, and Upper West regions of Ghana, respectively. A total of 488 healthy participants were recruited using the Clinical and Laboratory Standards Institute (United States National Consensus Committee on Laboratory Standards, NCCLS) Guidance Document C28A2. Medians for haematological parameters were calculated and reference values determined at 2.5th and 97.5th percentiles and compared with Caucasian values adopted by our laboratory as reference ranges and values from other African and Western countries. RBC count, haemoglobin, and haematocrit (HCT) were significantly higher in males compared to females. There were significant intraregional and interregional as well as international variations of haematological reference ranges in the populations studied. We conclude that, for each geographical area, there is a need to establish geography-specific reference ranges if accurate diagnosis and concise clinical decisions are to be made.

Related Concept Videos

Range00:59

Range

The range is one of the measures of variation. It can be defined as the difference between a dataset's highest and lowest values. For example, in the study of seven 16-ounce soda cans, the filled volume of soda was measured, thus producing the following amount (in ounces) of soda:
15.9; 16.1; 15.2; 14.8; 15.8; 15.9; 16.0; 15.5
Measurements of the amount of soda in a 16-ounce can vary since different subjects record these measurements or since the exact amount - 16 ounces of liquid, was not...
14.1K
Variation: Normal Distribution, Range, and Standard Deviation02:32

Variation: Normal Distribution, Range, and Standard Deviation

In the field of psychology, there are several ways to organize measurements of a trait, feature, or characteristic (i.e., variables). Qualitative data, such as ethnicity, can be tabulated into a frequency count to provide information about the proportion, as well as the variety of groups in a sample or population. On the other hand, researchers can perform a wider set of calculations on quantitative data. The mean, mode, and median, for instance, are central tendency measures to identify a...
27.6K
Inertial Frames of Reference01:03

Inertial Frames of Reference

Newton’s first law is usually considered to be a statement about reference frames. It provides a method for identifying a special type of reference frame: the inertial reference frame. In principle, we can make the net force on a body zero. If its velocity relative to a given frame is constant, then that frame is said to be inertial. So, by definition, an inertial reference frame is a reference frame where Newton's first law holds valid. Newton's first law applies to objects with...
8.7K
Non-inertial Frames of Reference01:27

Non-inertial Frames of Reference

A reference frame accelerating or decelerating relative to an inertial frame is a non-inertial frame. To help understand this, consider what taking off in an airplane, turning a corner in a car, riding a merry-go-round, and the circular motion of a tropical cyclone all have in common. All these systems are accelerating, decelerating, or rotating relative to the Earth; hence, they all are non-inertial frames. All these systems exhibit inertial forces, which merely seem to arise from motion,...
7.1K
IR Frequency Region: Fingerprint Region01:03

IR Frequency Region: Fingerprint Region

IR spectra are divided into two main regions: the diagnostic region and the fingerprint region. The diagnostic region of the spectrum lies above 1500 cm−1. The absorptions resulting from single-bond vibrations of the N–H, C–H, and O–H stretch at higher wavenumbers and appear on the left side of the spectrum. The stretching absorptions of the C≡C and C≡N occur between 2100–2300 cm−1. In contrast, those arising from stretching absorptions of the...
1.9K
¹H NMR: Long-Range Coupling01:27

¹H NMR: Long-Range Coupling

The coupling interactions of nuclei across four or more bonds are usually weak, with J values less than 1 Hz. While these are usually not observed in spectra, the presence of multiple bonds along the coupling pathway can result in observable long-range coupling.
In alkenes, spin information is communicated via σ–π overlap, as seen in allylic (four-bond) and homoallylic (five-bond) couplings. These coupling interactions are stronger when the σ bond is parallel to the alkene...
2.7K