Related Experiment Video

Updated: Jan 27, 2026

A Fabrication and Measurement Method for a Flexible Ferroelectric Element Based on Van Der Waals Heteroepitaxy
10:40

A Fabrication and Measurement Method for a Flexible Ferroelectric Element Based on Van Der Waals Heteroepitaxy

Published on: April 8, 2018

8.6K

Ferroelectric-Dielectric Mixed Buffer Layer for Enhanced Electrical Performance of Organic Ferroelectric Memory

Ju-Ryong Kim1, Amos Amoako Boampong2, Yoonseok Choi2

  • 1Department of Creative Convergence Engineering, Hanbat National University, Daejeon, 305-719 Republic of Korea.

Journal of Nanoscience and Nanotechnology
|March 28, 2019
PubMed

More Related Videos

The Effect of Anodization Parameters on the Aluminum Oxide Dielectric Layer of Thin-Film Transistors12:32

The Effect of Anodization Parameters on the Aluminum Oxide Dielectric Layer of Thin-Film Transistors

Published on: May 24, 2020

9.2K
Effect of Bending on the Electrical Characteristics of Flexible Organic Single Crystal-based Field-effect Transistors08:43

Effect of Bending on the Electrical Characteristics of Flexible Organic Single Crystal-based Field-effect Transistors

Published on: November 7, 2016

8.4K

Related Concept Videos

Buffers02:56

Buffers

A solution containing appreciable amounts of a weak conjugate acid-base pair is called a buffer solution, or a buffer. Buffer solutions resist a change in pH when small amounts of a strong acid or a strong base are added. A solution of acetic acid and sodium acetate is an example of a buffer that consists of a weak acid and its salt: CH3COOH (aq) + CH3COONa (aq). An example of a buffer that consists of a weak base and its salt is a solution of ammonia and ammonium chloride: NH3 (aq) + NH4Cl...
172.7K
Buffers: Buffer Capacity01:09

Buffers: Buffer Capacity

Buffer capacity is the quantitative measure of a buffer to resist the change in pH. As shown in the following equation, the buffer capacity, denoted by 'beta', is expressed as the number of moles of acid or base needed to change the pH of a one-liter buffer solution by 1 unit. Here, Ca and Cb indicate the number of moles of acid and base, respectively. Note that dpH represents the change in pH.
In the graph, pH is plotted as a function of the number of moles of base (Cb) added to a weak...
2.3K
Buffer Effectiveness02:19

Buffer Effectiveness

Buffer solutions do not have an unlimited capacity to keep the pH relatively constant . Instead, the ability of a buffer solution to resist changes in pH relies on the presence of appreciable amounts of its conjugate weak acid-base pair. When enough strong acid or base is added to substantially lower the concentration of either member of the buffer pair, the buffering action within the solution is compromised.
The buffer capacity is the amount of acid or base that can be added to a given volume...
55.1K
Capacitor With A Dielectric01:18

Capacitor With A Dielectric

Parallel plate capacitors consist of two conducting plates separated by a certain distance. However, it is mechanically difficult to hold the large plates parallel to each other without actual contact. Hence, a dielectric layer is commonly placed between the plates, which provides an easy solution for holding the plates together with a small gap and increases the capacitance of the capacitor.
Dielectrics are non-conducting materials with no free or loosely bound electrons. When a dielectric is...
4.9K
Field Effect Transistor01:29

Field Effect Transistor

Field-effect transistors (FETs) are integral to electronic circuits and distinguished by their three-terminal setup: the gate, drain, and source. These transistors operate as unipolar devices, which utilize either electrons or holes as charge carriers, in contrast to bipolar transistors, which use both types of carriers. The primary function of the FET is to modulate the flow of these carriers from the source to the drain through a channel. The voltage difference between the gate and source...
1.2K
Calculating pH Changes in a Buffer Solution02:45

Calculating pH Changes in a Buffer Solution

A buffer can prevent a sudden drop or increase in the pH of a solution after the addition of a strong acid or base up to its buffering capacity; however, such addition of a strong acid or base does result in the slight pH change of the solution. The small pH change can be calculated by determining the resulting change in the concentration of buffer components, i.e., a weak acid and its conjugate base or vice versa. The concentrations obtained using these stoichiometric calculations can be used...
58.3K