Related Experiment Video
Updated: Jan 27, 2026

Electroretinogram Recording in Larval Zebrafish using A Novel Cone-Shaped Sponge-tip Electrode
Published on: March 27, 2019
High-frequency characteristics of L- and M-cone driven electroretinograms
Avinash J Aher1, Mellina M Jacob2, Jan Kremers3
1Department of Ophthalmology, University Hospital Erlangen, Schwabachanlage 6, Erlangen 91054, Germany.
Abstract:
Electroretinograms (ERGs) elicited by high temporal frequency (26-95 Hz) L- and M-cone isolating sine-wave stimuli were investigated in human observers for full-field (FF) and different spatially restricted stimulus sizes (70°, 50°, 30°, and 10° diameter). Responses to L- and M-cone isolating FF stimuli were maximal around 48 Hz and decreased gradually with increasing temporal frequency up to 95 Hz. The response maximum was shifted to about 30-32 Hz for both L- and M-cone driven responses obtained with spatially restricted stimuli. The M-cone driven responses could only be measured up to 54 Hz with 70° stimuli. The response amplitudes for L- and M-cones and L-/M-cone amplitude ratios decreased with decreasing stimulus size. The ERG response phases to L- and M-cone isolating stimuli decreased with increasing temporal frequency and were about -160° apart for all stimulus sizes up to 34 Hz. Further increase in the temporal frequency displayed a positive correlation between stimulus size and L-M phase difference. The ERG data indicate that the responses evoked by high temporal frequency cone isolating stimuli reflect two mechanisms, one that is more centrally located and displays a maximum at about 30-32 Hz and a peripheral mechanism that is sensitive to higher temporal modulations. We propose that the peripheral mechanism (FF ERGs) reflects magnocellular activity, whereas the central mechanism (ERGs with spatially restricted stimuli) is based on a parvocellular activity up to about 30 Hz.
Related Concept Videos
Characteristics of Life
Frequency-dependent Selection
Characteristics of Fluids
Characteristics of Fluids
Fluids, which include both liquids and gases, are substances that deform continuously under shearing stress. For example, water and oil are liquids with molecules that can...
Characteristics of BJT
For input characteristics, the base-emitter voltage is varied, maintaining a constant collector-emitter voltage. This setup reveals a Shockley-type dependence of the collector current on...
Characteristics of JFET
The core of a JFET's operation is controlling drain current by modulating the gate-source voltage. When the drain and gate voltage are set to zero, the JFET exhibits no net current flow, representing a state of equilibrium. The drain current increases linearly as the...

