Whiter Than White: The Art of Delaying Detection in Sexual Killers

Ewa B Stefanska1, Adam J Carter2

  • 11 University of Roehampton, London, UK.

Related Concept Videos

Sexually Transmitted Infections01:26

Sexually Transmitted Infections

Sexually transmitted infections (STIs) are diseases transmitted primarily through unsafe sexual interactions. Bacteria, viruses, or parasites cause them and can result in severe health complications if untreated.ChlamydiaThe bacterium Chlamydia trachomatis is responsible for the disease Chlamydia, the most common STI in the United States. This peculiar pathogen requires human cells to reproduce, residing intracellularly. The initial infection often goes unnoticed because it typically does not...
972
Male Sexual Response: Erection & Ejaculation01:17

Male Sexual Response: Erection & Ejaculation

Sexual stimulation can take various forms, such as physical touch and visual or auditory cues. When this happens, the parasympathetic reflex in the sacral portion of the spinal cord is activated. This reflex stimulates the release of nitric oxide (NO), which then dilates the arterioles in the penis, increasing blood flow to the erectile tissues - the corpora cavernosa and corpus spongiosum.
The blood filling the erectile tissues compresses the veins, which helps to prevent blood from leaving...
20.0K
Development of the Sexual Organs in the Embryo and Fetus01:15

Development of the Sexual Organs in the Embryo and Fetus

Development of the reproductive organs in an embryo starts from a bipotential state. This means the early embryo can develop either male or female reproductive organs. The formation of these organs begins with the growth of gonadal ridges that arise from the intermediate mesoderm during the fifth week of development.
Near the gonadal ridges, two duct systems are present: the mesonephric ducts (Wolffian ducts) and paramesonephric ducts (Müllerian ducts). These ducts form the basis for the...
3.5K
Detection of Gross Error: The Q Test01:00

Detection of Gross Error: The Q Test

When one or more data points appear far from the rest of the data, there is a need to determine whether they are outliers and whether they should be eliminated from the data set to ensure an accurate representation of the measured value. In many cases, outliers arise from gross errors (or human errors) and do not accurately reflect the underlying phenomenon. In some cases, however, these apparent outliers reflect true phenomenological differences. In these cases, we can use statistical methods...
6.9K
Detection of Black Holes01:10

Detection of Black Holes

Although black holes were theoretically postulated in the 1920s, they remained outside the domain of observational astronomy until the 1970s.
Their closest cousins are neutron stars, which are composed almost entirely of neutrons packed against each other, making them extremely dense. A neutron star has the same mass as the Sun but its diameter is only a few kilometers. Therefore, the escape velocity from their surface is close to the speed of light.
Not until the 1960s, when the first neutron...
2.5K
Difference from Background: Limit of Detection01:05

Difference from Background: Limit of Detection

The limit of detection (LOD) is the smallest amount of analyte that can be distinguished from the background noise. The LOD value corresponds to the concentration at which the analyte signal is three times larger than the standard deviation of the blank signal. Below this value, the analyte signal cannot be differentiated from the background noise. It is calculated by dividing the calibration slope by 3 times the standard deviation of the blank signals.
The LOD indicates the presence or absence...
8.2K