Measurements of the production cross section and the branching fraction, and constraints on anomalous triple gauge

A M Sirunyan1, A Tumasyan1, W Adam2

  • 1Yerevan Physics Institute, Yerevan, Armenia.

The European Physical Journal. C, Particles and Fields
|April 19, 2019
PubMed

Related Concept Videos

Scalar and Vector Triple Products01:06

Scalar and Vector Triple Products

Two vectors can be multiplied using a scalar product or a vector product. The resultant of a scalar product is scalar, while with vector products, the resultant is a vector. These rules of the scalar or vector product between two vectors can be applied to multiple vectors to obtain meaningful combinations. The scalar triple product is the dot product of a vector with the cross product of two vectors.
The scalar triple product is the dot product of a vector with the cross product of two vectors....
4.4K
Cross Product01:25

Cross Product

The cross product is a fundamental concept in vector algebra that is a vector operation on two different vectors to obtain a third vector. Unlike the scalar product, the cross product results in a vector quantity perpendicular to both the original vectors.
The magnitude of the cross product is obtained by multiplying the magnitude of both the vectors and the sine of the angle between them. This means that a larger angle between the vectors will lead to a greater magnitude of the cross product.
873
Vector Product (Cross Product)01:17

Vector Product (Cross Product)

Vector multiplication of two vectors yields a vector product, with the magnitude equal to the product of the individual vectors multiplied by the sine of the angle between both the vectors and the direction perpendicular to both the individual vectors. As there are always two directions perpendicular to a given plane, one on each side, the direction of the vector product is governed by the right-hand thumb rule.
Consider the cross product of two vectors. Imagine rotating the first vector about...
27.7K
Pressure Gauges01:20

Pressure Gauges

Most pressure gauges, like those on scuba tanks, are calibrated to read zero at atmospheric pressure. Readings from such gauges are called the gauge pressure, which is the pressure relative to atmospheric pressure. When the pressure inside the tank exceeds atmospheric pressure, the gauge reports a positive value. Some gauges are designed to measure negative pressure. For example, many physics experiments must take place in a vacuum chamber, a rigid chamber from which some of the air is pumped...
5.2K
Constraints and Statical Determinacy01:26

Constraints and Statical Determinacy

In structural engineering, the equilibrium of a system is not only determined by its equations of equilibrium but also with the help of constraints. Constraints refer to restrictions on the motion of a system. The proper combinations of constraints can minimize the total number of constraints needed to maintain a system in mechanical equilibrium. When this happens, the system is said to be statically determinate. For such systems, the unknown reaction supports can be estimated using equilibrium...
966
Crossing Over01:34

Crossing Over

Unlike mitosis, meiosis aims for genetic diversity in its creation of haploid gametes. Dividing germ cells first begin this process in prophase I, where each chromosome—replicated in S phase—is now composed of two sister chromatids (identical copies) joined centrally.
The homologous pairs of sister chromosomes—one from the maternal and one from the paternal genome—then begin to align alongside each other lengthwise, matching corresponding DNA positions in a process...
169.7K