Integrating Bleeding Control Training Into Surgical Missions in Low- and Middle-Income Countries

Peter F Johnston1, Vennila Padmanaban1, Samba Jalloh2

  • 1Department of Surgery, Rutgers New Jersey Medical School, Newark, New Jersey.

Abstract

Related Concept Videos

Bleeding in Fresh Concrete01:22

Bleeding in Fresh Concrete

Bleeding in fresh concrete occurs when water from the mix rises to the surface. This happens because the mix's solid components fail to retain all the water as they settle, leading to separation where water collects at the top. The severity of bleeding can be measured by assessing the total settlement or by noting the decrease in height per unit height of concrete.
Bleeding can cause several issues in the concrete structure. Sometimes, the rising water gets trapped beneath large aggregate...
560
Definite Integral01:29

Definite Integral

Consider a real-valued function defined on a closed interval. One of the fundamental objectives in calculus is to determine the area under the graph of such a function. When an exact computation is not readily available, this area can be estimated by dividing the interval into a finite number of equal subintervals. Each subinterval corresponds to a rectangle whose width is the length of the subinterval and whose height is determined by the value of the function at a selected point within that...
53
Indefinite Integrals01:25

Indefinite Integrals

The water inflow rate into a storage tank is not constant but increases over time. Initially, the pump delivers water at a rate of 5 L/min. However, the inflow rate increases by 2 L/min for each additional minute due to rising pressure or system adjustments. This scenario can be described mathematically by a linear function:It is necessary to integrate the inflow rate function to measure the total volume of water added to the tank over time. The total water volume V(t) is obtained by performing...
61
Integrator and Differentiator01:13

Integrator and Differentiator

Op-amp circuits have significant applications in various fields, including automotive engineering. One such application is cruise control systems in cars, where op-amp circuits are integral for maintaining a constant speed. In these systems, op-amps function as both integrators and differentiators.
An integrator within an op-amp circuit produces an output directly proportional to the integral of the input signal. This is achieved by replacing the feedback resistor in a typical inverting...
1.4K
Integrated Healthcare System01:20

Integrated Healthcare System

An integrated healthcare system (IHS) is a set of organizations that provides for or arranges to provide coordinated and continuous service to a defined population. The IHS takes responsibility for that particular population's health status and outcome, both clinically and fiscally. An integrated healthcare system is a well-organized, well-coordinated, and collaborative network. The integrated delivery system is a network that connects different healthcare providers to deliver organized,...
2.4K
Control System Problem01:21

Control System Problem

In an open-loop system, such as a basic thermostat, the poles of the transfer function influence the system's response but do not determine its stability. However, when feedback is introduced to form a closed-loop system, such as an advanced thermostat that adjusts heating based on room temperature, stability is governed by the new poles of the closed-loop transfer function.
When forming a closed-loop system, issues can arise if the poles cross into the unstable region, leading to potential...
422