Effects of technology assumptions on US power sector capacity, generation and emissions projections: Results from the

Jared R Creason1, John E Bistline2, Elke L Hodson3

  • 1U.S. Environmental Protection Agency, 1200 Pennsylvania Avenue, Mail Code 6207J, Washington, DC 20460, USA.

Energy Economics
|May 11, 2019
PubMed

Related Concept Videos

Fischer Projections02:18

Fischer Projections

Learning to draw Fischer projections of molecules and understanding their relevance plays a crucial role in the visual depiction of organic molecules. A Fischer projection is a two-dimensional projection on a planar surface to simplify the three-dimensional wedge–dash representation of molecules. This is especially helpful in the case of molecules with multiple chiral centers that can be difficult to draw. Here, all the bonds of interest are represented as horizontal or vertical lines. While...
16.4K
Newman Projections02:06

Newman Projections

Different notations are used to represent the three-dimensional structure of molecules on two-dimensional surfaces. One of the most commonly used representations is the dash-wedge formula. The dashed wedges, solid wedges, and the plane lines indicate the groups situated behind the plane, coming out of the plane, and in the plane, respectively.
The organic molecules rotate across the single bonds leading to numerous temporary three-dimensional structures of varying energy known as...
20.6K
Coordinates and Map Projections01:29

Coordinates and Map Projections

Coordinates and map projections are essential tools in accurately representing the Earth's surface for various applications, ranging from navigation to spatial analysis. The latitude and longitude coordinate system is a universally recognized framework for defining locations. Latitude specifies the distance of a point north or south of the equator, measured in degrees from 0° at the equator to 90° at the poles. Longitude indicates a location's position east or west of the prime meridian,...
599
The Small x Assumption02:20

The Small x Assumption

If a reaction has a small equilibrium constant, the equilibrium position favors the reactants. In such reactions, a negligible change in concentration may occur if the initial concentrations of reactants are high and the Kc value is small. In such circumstances, the equilibrium concentration is approximately equal to its initial concentration.  This estimation can be used to simplify the equilibrium calculations by assuming that some equilibrium concentrations are equal to the initial...
49.5K
Back EMF01:24

Back EMF

Generators convert mechanical energy into electrical energy, whereas motors convert electrical energy into mechanical energy. A motor works by sending a current through a loop of wire located in a magnetic field. As a result, the magnetic field exerts a torque on the loop. This rotates a shaft, extracting mechanical work from the electrical current sent in initially. When the coil of a motor is turned, magnetic flux changes through the coil, and an emf (consistent with Faraday's law) is...
4.3K
Motional Emf01:22

Motional Emf

Magnetic flux depends on three factors: the strength of the magnetic field, the area through which the field lines pass, and the field's orientation with respect to the surface area. If any of these quantities vary, a corresponding variation in magnetic flux occurs. If the area through which the magnetic field lines are passing changes, then the magnetic flux also changes. This change in the area can be of two types: the flux through the rectangular loop increases as it moves into the...
4.0K