Related Experiment Video
Updated: Jan 24, 2026

In-situ Tapering of Chalcogenide Fiber for Mid-infrared Supercontinuum Generation
Published on: May 27, 2013
Efficient femtosecond mid-infrared generation based on a Cr:ZnS oscillator and step-index fluoride fibers
Abstract:
Femtosecond light sources in the 3-5 μm region are highly sought after for numerous applications. While they can be generated by using nonlinear effects in optical fibers, the efficiencies and effectiveness of frequency conversion can be significantly enhanced by using ultrashort driving pulses. Here, we report on a few-cycle Cr:ZnS oscillator driving low-order soliton dynamics in soft-glass fibers. By selecting appropriate parameters, sub-two-cycle pulses or broad supercontinua spanning over 1.7 octaves from 1.6 to 5.1 μm can be generated at average power levels exceeding 300 mW. In the same setting, Raman-induced soliton self-frequency shifting has been exploited to generate sub-100-fs pulses continuously tunable from 2.3 to 3.85 μm with a conversion efficiency of ∼50%. These results demonstrate the vast potential of using Cr:ZnS or Cr:ZnSe lasers for powerful mid-infrared generation.
Related Concept Videos
Oscillations In An LC Circuit
Forced Oscillations
Damped Oscillations
Although friction and other non-conservative...
Oscillations about an Equilibrium Position
Rate-Determining Steps
In a multistep reaction mechanism, one of the elementary steps progresses significantly slower than the others. This slowest step is called the rate-limiting step (or rate-determining step). A reaction cannot proceed faster than its slowest step, and hence, the rate-determining step limits the overall reaction rate.
The concept of rate-determining step can be understood from the analogy of a 4-lane freeway with a short-stretch of traffic-bottleneck caused due to...
Classification of Skeletal Muscle Fibers
Slow-Twitch Muscle Fibers
Slow oxidative, muscle fibers appear red due to large numbers of capillaries and high levels of...

