Effect of different concentrations of l-carnitine in extender for semen cryopreservation in sheep

Clara Vieira de Souza1, Felipe Zandonadi Brandão1, Juliana Dantas Rodrigues Santos1

  • 1Faculdade de Medicina Veterinária, Universidade Federal Fluminense, Rua Vital Brasil Filho, 64, Niterói, RJ, 24320-340, Brazil.

Cryobiology
|May 24, 2019
PubMed

Related Concept Videos

Sperm Structure and Semen Composition01:22

Sperm Structure and Semen Composition

During ejaculation, males release around 2-5 milliliters of semen, which is a complex mixture of mature sperm and various fluids produced by accessory glands. The mature sperm cells measure approximately 60 micrometers in length and consist of a head, neck, midpiece, and tail. The head is flattened and tapered, measuring about 4 to 5 micrometers in length. It contains a nucleus with condensed chromosomes and an acrosome, a cap-like structure filled with enzymes essential for penetrating the...
10.8K
Cloning of Dolly the Sheep01:08

Cloning of Dolly the Sheep

The first successfully cloned mammal was Dolly, a sheep, born on 5th July 1996 at Roslin Institute, Scotland. The cloned sheep was named after the American singer Dolly Parton. Dolly lived for seven years and died of respiratory complications, which is speculated to be due to the actual age of her DNA. Because the DNA in cloned cells belongs to an older individual,  the cloned individual’s life expectancy may be affected. Indeed, analysis of Dolly’s DNA revealed shorter...
7.3K
Concentration Cells02:41

Concentration Cells

A concentration cell is a type of a  voltaic cell constructed by connecting two almost identical half-cells, both based on the same half-reaction and using the same electrode, differing only in the concentration of one redox species. A concentration cell's potential, therefore, is determined only by the concentration difference of the particular redox species.
Consider the following voltaic cell:
25.6K
Solution Concentration and Dilution02:59

Solution Concentration and Dilution

The relative amount of a given solution component is known as its concentration. Often, though not always, a solution contains one component with a concentration that is significantly greater than that of all other components. This component is called the solvent and may be viewed as the medium in which the other components are dispersed or dissolved. Solutions in which water is the solvent are, of course, very common on our planet. A solution in which water is the solvent is called an aqueous...
128.2K
Stress Concentrations01:13

Stress Concentrations

The concept of stress concentration is crucial for understanding how materials respond under bending stresses, particularly when there are irregularities or discontinuities in the material's geometry. Normally, stress in a symmetric member subjected to pure bending is assumed to be uniformly distributed across the entire cross-section. However, this assumption does not hold when there are variations in the cross-sectional geometry or the presence of notches and holes.
The stress...
613
Stress Concentrations01:24

Stress Concentrations

Stress concentration is when stress intensifies near discontinuities such as holes or abrupt cross-sectional changes in a structural member. This localized stress can often surpass the average stress within the member. The stress distribution in flat bars, either with a circular hole or varying widths connected by fillets, can be determined experimentally using a photoelastic method. The results are based on ratios of geometric parameters like the ratio of the hole's radius to the smaller...
646