Transcranial direct current stimulation in the treatment of cerebellar ataxia: A two-phase, double-blind,

Thiago Lima Barretto1, Igor Dórea Bandeira1, João Gabriel Jagersbacher1

  • 1Department of Neuroscience and Mental Health, Medical School of Bahia, Federal University of Bahia, Salvador, Bahia, Brazil.

Abstract

Related Concept Videos

Blind Procedures02:07

Blind Procedures

Ideally, the people who observe and record the children’s behavior are unaware of who was assigned to the experimental or control group, in order to control for experimenter bias. Experimenter bias refers to the possibility that a researcher’s expectations might skew the results of the study. Remember, conducting an experiment requires a lot of planning, and the people involved in the research project have a vested interest in supporting their hypotheses. If the observers knew which...
13.4K
Action Potential: Phases of Stimulation01:28

Action Potential: Phases of Stimulation

The action potential is a complex electrical event that occurs in excitable cells, such as neurons and muscle cells. It consists of several distinct phases, each with specific characteristics.
Resting Phase:
In this phase, the cell's membrane is at its resting potential, typically around -70 millivolts (mV) for neurons. Inside the cell, there is a higher concentration of potassium ions (K+) and a lower concentration of sodium ions (Na+). Voltage-gated sodium channels are closed, and...
11.8K
Blinding01:11

Blinding

Blinding is a commonly used method of not telling participants which treatment a subject is receiving. Blinding is a critical part of a randomized control trial or RCT. It reduces the bias that affects the results. In an RCT, blinding is used in the form of a placebo. A placebo effect occurs when untreated subjects falsely believe they have received the treatment and report improved symptoms. A placebo or a dummy treatment is administered to subjects to negate the bias caused by such an effect.
3.8K
Sign Test for Matched Pairs01:17

Sign Test for Matched Pairs

The sign test for matched pairs offers a robust method for comparing two paired samples, often for the effects of an intervention in one of them. This method is very useful in situations where the underlying distribution of the data is unknown. The test compares two related samples—often pre- and post-treatment measurements on the same subjects—to determine if there are significant differences in their median values.
To conduct the sign test, we first calculate the differences in...
392
Pilot and Numeric Relaying01:21

Pilot and Numeric Relaying

Pilot relaying is a type of differential protection used in power systems. It compares electrical quantities at the terminals of equipment via a communication channel instead of direct relay interconnection. This method is essential for transmission lines where the terminals are far apart, typically up to 80 km for lines with 69 to 115 kV ratings. Four types of communication channels are used for pilot relaying:
485
Phase Diagrams02:39

Phase Diagrams

A phase diagram combines plots of pressure versus temperature for the liquid-gas, solid-liquid, and solid-gas phase-transition equilibria of a substance. These diagrams indicate the physical states that exist under specific conditions of pressure and temperature and also provide the pressure dependence of the phase-transition temperatures (melting points, sublimation points, boiling points). Regions or areas labeled solid, liquid, and gas represent single phases, while lines or curves represent...
49.9K