Related Experiment Video
Updated: Jan 24, 2026

Development of Sulfidogenic Sludge from Marine Sediments and Trichloroethylene Reduction in an Upflow Anaerobic Sludge Blanket Reactor
Published on: October 15, 2015
Soluble substrate removal determination through intracellular storage in high-rate activated sludge systems using
Thomas M Nogaj1, Arifur Rahman2, Mark W Miller3
1Cardno, 380 Park Place Blvd, Suite 300, Clearwater, FL, 33759, USA.
Abstract:
In high-rate activated sludge (HRAS) systems, extracellular adsorption and intracellular storage have been referred to as the dominant mechanisms for capturing organic carbon from wastewater. However, the quantification of storage products under short sludge retention time (SRT) of HRAS systems has rarely been studied. Since the measurement of storage products is complex and dependent on several variables, alternative solutions for substrate removal through storage are required to understand the high-rate system's carbon capture efficiency. To overcome the complexity of storage quantification experimentally, this study proposes a fundamental approach of determining the intracellular storage products from soluble organic carbon removal of domestic wastewater. A substrate partitioning approach was used which represents influent total chemical oxygen demand (COD) removal through storage, extracellular polymeric substance, biomass growth and energy production. The substrate partitioning approach based on stoichiometric analysis showed that storage accounted for 7-11% of influent soluble COD removal in A-stage systems operated at SRT range of 0.3-2 d. The stoichiometric analysis also showed that soluble COD removal through storage is dependent on dissolved oxygen (DO) level and removal through storage increased from 8% to 30% (influent soluble COD) when the DO level decreased from 2 to 0.01 mg/L at SRT of 1.5 d.
Related Concept Videos
Rate-Determining Steps
In a multistep reaction mechanism, one of the elementary steps progresses significantly slower than the others. This slowest step is called the rate-limiting step (or rate-determining step). A reaction cannot proceed faster than its slowest step, and hence, the rate-determining step limits the overall reaction rate.
The concept of rate-determining step can be understood from the analogy of a 4-lane freeway with a short-stretch of traffic-bottleneck caused due to...
Reaction Rate
The mathematical representation of the change in the concentration of reactants and products, over time, is the rate...
Solubility Equilibria
The...
Balancing Redox Equations
Physical Properties Affecting Solubility
As for any solution, the solubility of a gas in a liquid is affected by the attractive intermolecular forces between solute and solvent species. Unlike solid and liquid solutes, however, there is no solute-solute intermolecular attraction to overcome when a gaseous solute dissolves in a liquid solvent since the atoms or molecules comprising a gas are far separated and experience negligible interactions. Consequently, solute-solvent interactions are the sole...
Factors Affecting Solubility

