Drivers' estimation of their travelling speed: a study on an expressway and a local road

Qinaat Hussain1,2, Wael K M Alhajyaseen1, Kris Brijs2

  • 1a College of Engineering, Qatar Transportation and Traffic Safety Center, Qatar University , Doha , Qatar.

Related Concept Videos

Average Velocity01:12

Average Velocity

To calculate the other physical quantities in kinematics, we must introduce the time variable. The time variable allows us not only to state the position of the object during its motion, but also how fast it is moving. The speed at which an object is moving is given by the rate at which the position changes with time. For each position xi, we assign a particular time ti. If the details of the motion at each instant are not important, the rate is usually expressed as the average velocity. This...
Kinematic Equations - II01:17

Kinematic Equations - II

The second kinematic equation expresses the final position of an object in terms of its initial position, the distance traveled with the initial constant velocity, and the distance traveled due to a change in velocity. Similar to the first kinematic equation, this equation is also only valid when the acceleration is constant throughout the motion of an object.
Suppose a car merges into freeway traffic on a 200 m long ramp. If its initial velocity is 10 m/s and it accelerates at 2 m/s2, then the...
Application of Rates of Change01:18

Application of Rates of Change

The movement of a car along a highway can be examined through key principles of calculus and kinematics. As the car travels, its position varies over time and can be represented mathematically as a function of time. Analyzing the rate of these changes enables the measurement of velocity and acceleration, fundamental aspects of motion analysis.Velocity describes how position changes over time. The average velocity during a specific time interval is calculated by dividing the change in position...
Introduction to Limits01:30

Introduction to Limits

A limit describes the value a function approaches as its input moves closer to a particular point. Even when a function is undefined at a specific value, limits allow us to analyze its behavior near that point. This concept is fundamental in calculus and essential for understanding continuity, derivatives, and integrals.Mathematically, a function f(x) has a limit L at x = a if its values L approach x as x gets arbitrarily close to a. This is written as:This notation expresses that the function...
Trapezoidal Rule01:26

Trapezoidal Rule

Estimating the distance traveled by a vehicle using its recorded velocity over time is a common problem in physics and engineering. When velocity data is available at discrete time intervals, rather than as a continuous function, numerical integration methods such as the trapezoidal rule are often employed to approximate the total displacement.The trapezoidal rule works by dividing the total time interval into several equal segments. Within each segment, the recorded velocities at the endpoints...
Vectors in 2D: Problem Solving01:29

Vectors in 2D: Problem Solving

A plane traveling due north at 180 km/h in still air was found to be 80 km off-course after 30 minutes, deviating approximately 5 degrees east of north. This deviation means the influence of a crosswind alters the plane’s intended trajectory. The actual ground path formed a diagonal, suggesting that the aircraft’s effective ground speed was reduced to 160 km/h and directed slightly to the east due to the wind.By analyzing the displacement from the intended path, the velocity contributed by the...