Related Experiment Video
Updated: Jan 24, 2026

Fabrication of Decellularized Cartilage-derived Matrix Scaffolds
Published on: January 7, 2019
A biomimetic cartilage gradient hybrid scaffold for functional tissue engineering of cartilage
Xueyan Hu1, Wenfang Li1, Liying Li1
1State Key Laboratory of Fine Chemicals, Dalian R&D Center for Stem Cell and Tissue Engineering, Dalian University of Technology, Dalian 116024, China.
Abstract:
Osteochondral tissue has a complex layered structure that is not self-repairing after a cartilage defect. Therefore, constructing a biomimetic gradient scaffold that meets the specific structural requirements of osteochondral tissue is a major challenge in the field of cartilage tissue engineering. In this study, chitosan/Sodium β-glycerophosphate/Gelatin (Cs/GP/Gel) biomimetic gradient scaffolds were prepared by regulating the mass ratio of single layer raw materials. The same ratio of Cs/GP/Gel hybrid scaffold material was used as the control. Physical properties such as water absorption, porosity and the degradation rate of the material were compared to optimize the proportion of scaffold materials. P3 Bone Mesenchymal Stem Cells (BMSCs) were inoculated on the gradient and the control scaffolds to investigate its biocompatibility. Scanning electron microscopy (SEM) results show that 3:1:2, 6:1:3.5, 9:1:5, 12:1:6.5, 15:1:8 Cs/GP/Gel gradient scaffolds had excellent three-dimensional porous structures. Channels were also shown to have been interconnected, and the walls of the pores were folded. In the longitudinal dimension, gradient scaffolds had an obvious stratified structure and pore gradient gradualism, that effectively simulated the natural physiological stratified structure of real cartilage. The diameter of the pores in the control scaffold was uniform and without any pore gradient. Gradient scaffolds had good water absorption (584.24 ± 3.79˜677.47 ± 1.70%), porosity (86.34 ± 5.10˜95.20 ± 2.86%) and degradation (86.09 ± 2.46˜92.48 ± 3.86%). After considering the physical properties assessed, the Cs/GP/Gel gradient scaffold with a ratio of 9:1:5 was found to be the most suitable material to support osteochondral tissue. BMSCs were subsequently inoculated on the proportional gradient and hybrid scaffolds culture. These cells survived, distributed and extended well on the gradient and hybrid scaffold material. The biomimetic gradient scaffold designed and prepared in this study provides an important foundation for the development of new gradient composite biomedical materials for osteochondral repair.
Related Concept Videos
Growth of Cartilage and Bone Tissue
What is an Electrochemical Gradient?
The chemical gradient relies on differences in the abundance of a substance on the outside versus the inside of a cell and flows from areas of high to low ion concentration. In contrast, the electrical gradient revolves around an...
Structural Protein Function
Collagen, the most abundant protein in mammals, is found throughout the body. In connective tissue, such as skin, ligaments, and tendons, it provides tensile strength and elasticity. In bones and teeth, it mineralizes to...
Hybrid Zones
Epithelial Tissues and Their Functions
Epithelial tissues provide the body's first line of protection from physical,...
Functions of Connective Tissues
Hard connective tissues, such as bones and cartilage, provide structure and support to the body.

