Related Experiment Video
Updated: Jan 24, 2026

Finite Element Modeling for the Simulation of the Quasi-Static Compression of Corrugated Tapered Tubes
Published on: January 6, 2023
Comparison of porcine brain mechanical properties to potential tissue simulant materials in quasi-static and
D Singh1, S Boakye-Yiadom2, D S Cronin1
1Department of MME, University of Waterloo, 200 University Avenue West, Waterloo, Canada.
Abstract:
In both finite element and physical surrogate models of head blast injury, accurate material properties of the brain and/or tissue simulants are necessary to ensure biofidelity in predicted response. Thus, there is a need for experimental comparisons between tissue and simulant materials under the same experimental conditions. This study compares the response of porcine brain tissue and a variety of brain tissue simulants in quasi-static and sinusoidal compression tests. Fresh porcine brain tissue was obtained from a local abattoir and tested within 4 h post mortem. Additionally, the effect of post mortem time was investigated by comparing samples stored at room temperature and stored frozen (-18 °C), at various time intervals. The brain tissue simulants tested were bovine gelatin (3%, 5%, and 10% concentration), agarose gelatin (e0.4%, 0.6%, 0.8% concentration), and Sylgard 527. The experiments were performed using a DMA apparatus (TA Instruments Q800). The quasi-static compression data were fit to Ogden hyperelastic functions so that parameters could be compared. It was found that bovine gelatin at 3% and 5% concentration demonstrated the closest response to brain tissue in quasi-static compression. Conversely, in sinusoidal compression, the agarose gel and Sylgard 527 were found to be in closer agreement with the tissue, than bovine gel. In terms of post mortem time and storage, there was no statistically significant difference detected in the response of tissue samples after 48 h, regardless of storage method. However, samples stored at room temperature after 48 h appeared to demonstrate a reduction in stiffness.
More Related Videos
11:19Characterizing Multiscale Mechanical Properties of Brain Tissue Using Atomic Force Microscopy, Impact Indentation, and Rheometry
Published on: September 6, 2016
06:54A Virtual Simulation Experiment of Mechanics: Material Deformation and Failure Based on Scanning Electron Microscopy
Published on: January 20, 2023
Related Concept Videos
Sinusoidal Sources
In homes, the power supplies use sinusoidal sources to provide electricity. These sources generate a voltage that varies sinusoidally...
Exponential and Sinusoidal Signals
Static Equilibrium - I
Static Equilibrium - II
Static Friction
For example, consider a scenario where a truck is connected to a car by a rope, ready to tow it along a road. When no external force is applied by the truck, the car remains stationary and is said to be in static equilibrium. In this case, the forces acting on the car, such as gravity and the...
Graphical and Analytic Representation of Sinusoids
The first step is measuring the peak-to-peak value, which is twice the amplitude of the sinusoid. This provides information about the maximum voltage swing of the waveform.
Secondly, the period and angular frequency are determined. The period is the time taken for one complete cycle of the waveform, while...