Quantifying the ossification of the carpus in skeletal age estimation: Radiographic standards for Australian

M S Reynolds1, D M MacGregor1, C L Alston-Knox2

  • 1Skeletal Biology and Forensic Anthropology Research Laboratory, School of Biomedical Sciences, Faculty of Health, Queensland University of Technology, Brisbane, Queensland, Australia.

Related Concept Videos

Estimating Population Standard Deviation01:26

Estimating Population Standard Deviation

When the population standard deviation is unknown and the sample size is large, the sample standard deviation s is commonly used as a point estimate of σ. However, it can sometimes under or overestimate the population standard deviation. To overcome this drawback, confidence intervals are determined to estimate population parameters and eliminate any calculation bias accurately. However, this only applies to random samples from normally distributed populations. Knowing the sample mean and...
3.3K
Estimating Population Mean with Known Standard Deviation01:16

Estimating Population Mean with Known Standard Deviation

To construct a confidence interval for a single unknown population mean μ, where the population standard deviation is known, we need sample mean as an estimate for μ and we need the margin of error. Here, the margin of error (EBM) is called the error bound for a population mean (abbreviated EBM). The sample mean is the point estimate of the unknown population mean μ.
The confidence interval estimate will have the form as follows:
(point estimate - error bound, point estimate +...
9.6K
Estimating Population Mean with Unknown Standard Deviation01:22

Estimating Population Mean with Unknown Standard Deviation

In practice, we rarely know the population standard deviation. In the past, when the sample size was large, this did not present a problem to statisticians. They used the sample standard deviation s as an estimate for σ and proceeded as before to calculate a confidence interval with close enough results. However, statisticians ran into problems when the sample size was small. A small sample size caused inaccuracies in the confidence interval.
William S. Gosset (1876–1937) of the...
8.8K
Bone Formation by Intramembranous Ossification01:29

Bone Formation by Intramembranous Ossification

Intramembranous ossification is one of the two processes involved in the development of bones within an embryo. The flat bones of the face, most of the cranial bones, and the clavicles are formed via this process. During intramembranous ossification, the bones develop directly from sheets of undifferentiated mesenchymal connective tissue.
The process begins when mesenchymal cells in the embryonic skeleton gather together and differentiate into osteogenic cells, which then develop into ...
10.4K
What are Estimates?01:06

What are Estimates?

It isn't easy to measure a parameter such as the mean height or the mean weight of a population. So, we draw samples from the population and calculate the mean height or mean weight of the individuals in the sample. This sample data acts as a representative measure of the population parameter. These sample statistics are known as estimates. 
The estimate for the mean of a sample is denoted by ͞x, whereas the mean of the population is designated as μ. Further, parameters such...
8.2K
Bone Formation by Endochondral Ossification01:24

Bone Formation by Endochondral Ossification

Bone formation, or ossification, begins around the sixth to seventh week of embryonic development. Most bones develop from a cartilaginous template through the process of endochondral ossification. Cartilage formation begins when clusters of mesenchymal cells differentiate into chondrocytes. These chondrocytes proliferate rapidly and secrete an extracellular matrix that becomes encased in a membrane called the perichondrium. The resulting cartilage model provides a template that resembles the...
8.7K