The representation selection problem: Why we should favor the geometric-module framework of spatial reorientation

Alexandre Duval1

  • 1Department of Philosophy, University of Sheffield, United Kingdom.

Cognition
|June 25, 2019
PubMed

Related Concept Videos

Geometric Mean01:15

Geometric Mean

The mean is a measure of the central tendency of a data set. In some data sets, the data is inherently multiplicative, and the arithmetic mean is not useful. For example, the human population multiplies with time, and so does the credit amount of financial investment, as the interest compounds over successive time intervals.
In cases of multiplicative data, the geometric mean is used for statistical analysis. First, the product of all the elements is taken. Then, if there are n elements in the...
3.9K
Sign Test for Matched Pairs01:17

Sign Test for Matched Pairs

The sign test for matched pairs offers a robust method for comparing two paired samples, often for the effects of an intervention in one of them. This method is very useful in situations where the underlying distribution of the data is unknown. The test compares two related samples—often pre- and post-treatment measurements on the same subjects—to determine if there are significant differences in their median values.
To conduct the sign test, we first calculate the differences in...
386
Control Volume and System Representations01:16

Control Volume and System Representations

Two key frameworks are employed to analyze mass, energy, and momentum transfer: the control volume approach and the system approach. These frameworks offer different perspectives, depending on whether the focus is on a specific region in space (control volume approach) or a defined mass of fluid (system approach).
The control volume approach considers a stationary region in space through which fluid flows. This region is bounded by a control surface.  For instance, in the case of water...
1.5K
Gibbs Free Energy and Thermodynamic Favorability02:23

Gibbs Free Energy and Thermodynamic Favorability

The spontaneity of a process depends upon the temperature of the system. Phase transitions, for example, will proceed spontaneously in one direction or the other depending upon the temperature of the substance in question. Likewise, some chemical reactions can also exhibit temperature-dependent spontaneities. To illustrate this concept, the equation relating free energy change to the enthalpy and entropy changes for the process is considered:
8.1K
State Space Representation01:27

State Space Representation

The frequency-domain technique, commonly used in analyzing and designing feedback control systems, is effective for linear, time-invariant systems. However, it falls short when dealing with nonlinear, time-varying, and multiple-input multiple-output systems. The time-domain or state-space approach addresses these limitations by utilizing state variables to construct simultaneous, first-order differential equations, known as state equations, for an nth-order system.
Consider an RLC circuit, a...
540
Graphical and Analytic Representation of Sinusoids01:20

Graphical and Analytic Representation of Sinusoids

Analyzing two sinusoidal voltages with equal amplitude and period but different phases on an oscilloscope, an instrument used to display and analyze waveforms, involves a three-step process.
The first step is measuring the peak-to-peak value, which is twice the amplitude of the sinusoid. This provides information about the maximum voltage swing of the waveform.
Secondly, the period and angular frequency are determined. The period is the time taken for one complete cycle of the waveform, while...
921