Related Experiment Video
Updated: Jan 21, 2026

Tail Vein Transection Bleeding Model in Fully Anesthetized Hemophilia A Mice
Published on: September 30, 2021
Low-dose Immune Tolerance Induction in Hemophilia: A Single-Center Experience
Bulent Zulfikar1, Basak Koc, Nihal Ozdemir
1Department of Pediatric Hematology and Oncology, Cerrahpasa Medical Faculty and Oncology Institute, Istanbul University, Istanbul, Turkey.
Introduction:
The development of inhibitors against factors VIII/IX is the most serious complication in hemophilia. The best treatment strategy for inhibitor eradication is immune tolerance induction (ITI). The aim of this study was to evaluate patients treated with low-dose ITI at a single center with limited resources.
Materials And Methods:
In total, 29 (8.05%) of 360 hemophilia A patients exhibited inhibitors. The data from hemophilia patients with inhibitors undergoing ITI between 1999 and 2017 were collected and analyzed.
Results:
Seventeen ITIs administered to 15 hemophilia A patients with inhibitors were analyzed, and the data from 13 ITIs conducted in 12 patients were evaluated. The median age at ITI onset was 10 years (range: 1.25 to 52 y). The maximum inhibitor titer before ITI was 30 Bethesda Units (BU) (range: 4.48 to 135), and the median inhibitor titer was 1.25 BU (range: 0 to 5.6) at the onset of ITI. The median time interval between the inhibitor development and ITI onset was 60 months (range: 7 to 264 mo). The median inhibitor titer during ITI was 3.4 BU (range: 0 to 158.7). At the end of the treatment, 4 of the 12 patients (33.3%) exhibited a complete response, 4 (33.3%) had partial responses (with continuing ITI), and 4 (33.3%) exhibited ITI failure.
Conclusions:
Treatment of hemophilia patients with inhibitors is challenging, and ITI is the best treatment method; however, a high-dose daily ITI regimen cannot be given to every patient in every country due to its high cost. Our results show that low-dose ITI may be a choice for selected patients with inhibitors.
Related Concept Videos
Inductance: Single-Phase And Three-Phase Line
Single-Phase Two-Wire Line:
A single-phase line consists of two solid cylindrical conductors, denoted as x and y. Each conductor carries phasor currents ix and iy, respectively. Given that the sum of these currents is...
Bioavailability Study Design: Single Versus Multiple Dose Studies
Lattice Centering and Coordination Number
Types of Unit Cells
Imagine taking a large number of identical...
Center of Gravity
Center of Gravity
To determine its location, the principle of moments can be utilized by dividing the object into...
Center of Mass
The knowledge of the center of mass can also help us to describe and predict the motion of objects. For example, when a ball is thrown...

