Linking Friction and Surface Properties of Hydrogels Molded Against Materials of Different Surface Energies

Biological tissues subjected to rubbing, such as the cornea and eyelid or articular cartilage, are covered in brushy, hydrated mucous structures in order to reduce the shear stress on the tissue. To mimic such biological tissues, we have prepared polyacrylamide (PAAm) hydrogels with various concentrations of un-cross-linked chains on their surfaces by synthesizing them in molds of different surface energies. The selected molding materials included hydrophilic glass, polyoxymethylene (POM), polystyrene (PS), polyethylene (PE), polypropylene (PP), and polytetrafluoroethylene (PTFE). After synthesis, demolding, and equilibration in water, the elastic modulus at the hydrogel surface decreased with increasing water contact angle of the mold. The softer, brushier surfaces did not completely collapse under compressive pressures up to 10 kPa, remaining better hydrated compared to their denser, cross-linked analogs. The hydrogels with brushier surfaces displayed an order of magnitude lower coefficient of friction than the cross-linked ones, which is attributed to the ability of their near-surface regions to retain larger amounts of liquid at the interface. The characteristic speed-dependent friction of the denser, cross-linked hydrogel surface is compared to the speed-independent friction of the brushy hydrogels and discussed from the perspectives of (elasto)hydrodynamic lubrication, permeability, and shear-induced hydrodynamic penetration depth.