Related Experiment Video
Updated: Jan 20, 2026

Author Spotlight: Enhancing Rheumatoid Arthritis Research Through HR-pQCT Imaging Analysis
Published on: October 6, 2023
A novel quantitative method for estimating bone mineral density using B-mode ultrasound and radiofrequency signals-a
Violeta-Claudia Bojincă1, Claudiu C Popescu2, Raluca-Daniela Decianu1
1Internal Medicine and Rheumatology Department, Sfânta Maria Clinical Hospital, Carol Davila University of Medicine and Pharmacy, Bucharest 011172, Romania.
Abstract:
The objective of the present study was to evaluate whether an innovative quantitative ultrasound (QUS) technique, Radiofrequency Echographic Multi Spectromety, which combines B-mode ultrasound and radiofrequency signals, is reliable in typical Romanian patients compared to previous results obtained using dual-energy X-ray absorptiometry (DXA). The study prospectively included previously unscreened post-menopausal females with rheumatoid arthritis (RA) and age-matched healthy controls. Bone mineral density (BMD) measurements were performed with an EchoS machine (Echolight®), which combines B-mode ultrasound and radiofrequency signals. The study included 106 RA patients, with a median disease duration of 3.2 (0.5-22) years and 119 controls. RA patients had a significantly lower body weight, body mass index (BMI) and basal metabolic rate (BMR) than the controls, while the prevalence of obesity and body fat differed insignificantly. RA patients had a significantly lower spine and hip BMD, higher fracture risk and higher prevalence of osteoporosis. Compared to RA patients without osteoporosis, those with osteoporosis were significantly older and had a longer menopause duration, but they had a significantly lower BMI, body fat, BMR and prevalence of obesity. Among the controls and RA patients, the median spine and hip BMD became significantly higher as the BMI increased from underweight to obesity. In conclusion, osteoporosis is prevalent among RA patients, as a part of a complex transformation of body mass composition, involving BMI and fat mass. The novel QUS scanning technique was able to replicate the results of the established DXA measurement of BMD and is potentially suitable for screening wide populations for osteoporosis.
More Related Videos
09:31Generation of Induced-pluripotent Stem Cells Using Fibroblast-like Synoviocytes Isolated from Joints of Rheumatoid Arthritis Patients
Published on: October 16, 2016
07:44Author Spotlight: Implementation of BIVA for Analyzing Disease Risk Factors in Patients with Low Body Cell Mass
Published on: July 14, 2023
Related Concept Videos
Essential Minerals for Bone Health
Calcium and Phosphorus
Calcium is a critical component of bones, especially in the form of calcium phosphate and calcium carbonate. Since the body cannot make calcium, it must be obtained from the diet. However, calcium cannot be absorbed from the small intestine without...
Water and Mineral Acquisition
Pilot and Numeric Relaying
Minerals
Major...
What is a Mode?
There can be more than one mode in a data set if multiple values have the same highest frequency. For instance, suppose that the Statistics exam scores of 20 students are: 50; 53; 59; 59; 63; 63; 72; 72; 72; 72; 72; 76; 78; 81; 83; 84; 84; 84; 90; 93. Here, the mode is 72, as it occurs most frequently, five times.
A data set with two modes is called bimodal. For example,...
What are Estimates?
The estimate for the mean of a sample is denoted by ͞x, whereas the mean of the population is designated as μ. Further, parameters such...