Perylene Diimide and Luminol as Potential-Resolved Electrochemiluminescence Nanoprobes for Dual Targets Immunoassay...

In the field of clinical diagnosis, it is important to construct a potential-resolved multiplex electrochemiluminescence (ECL) biosensor for decreasing the false-positive rate and improving the diagnostic accuracy. However, the shortage of low-potential cathodic luminophores between -1 and 0 V (vs Ag/AgCl) severely limited the development of the biosensor. Herein, we synthesized a novel luminophore N,N-bis-(3-dimethyl aminopropyl)-3,4,9,10-perylene tetracarboxylic acid diimide (PDI), which gave dual emissions at -0.25/-0.26 V with K₂S₂O₈ as a co-reactant in aqueous solution. The ECL was assigned to excited J-type PDI dimers. Then, PDI and luminol were used as luminophores to respectively combine with graphite oxide and gold nanoparticles and form potential-resolved ECL nanoprobes. Also, this potential-resolved ECL nanoprobes were respectively functionalized by secondary antibodies (Ab₂) to construct a low-potential sandwiched ECL immunosensor for tumor markers carcinoembryonic antigen (CEA) and α-fetoprotein (AFP) simultaneous determination during linear scanning potential range from -0.6 to 0.6 V. The prepared multiplex immunosensor exhibited sensitive ECL response for CEA at -0.6 V due to PDI and that for AFP at 0.6 V due to luminol, and both linear semilogarithmical ranges were from 0.1 pg to 1 ng mL^-1. In addition, PDI with dual ECL peaks showed enticing prospect of built-in self-calibration for a precise quantitative and bioimaging analysis.