Related Experiment Video

Updated: Jan 20, 2026

Making Record-efficiency SnS Solar Cells by Thermal Evaporation and Atomic Layer Deposition
14:01

Making Record-efficiency SnS Solar Cells by Thermal Evaporation and Atomic Layer Deposition

Published on: May 22, 2015

43.3K

Efficient Polymer Solar Cells with Open-Circuit Voltage of 1.01 V and Power Conversion Efficiency of 8.09

Simei Zeng1, Huixin Qi1, Bohan Yu1

  • 1Key Laboratory of Luminescence and Optical Information, Ministry of Education, Beijing Jiaotong University, Beijing 100044, People's Republic of China.

ACS Omega
|August 29, 2019
PubMed

More Related Videos

Monovalent Cation Doping of CH3NH3PbI3 for Efficient Perovskite Solar Cells08:30

Monovalent Cation Doping of CH3NH3PbI3 for Efficient Perovskite Solar Cells

Published on: March 19, 2017

17.1K
Integrating a Triplet-triplet Annihilation Up-conversion System to Enhance Dye-sensitized Solar Cell Response to Sub-bandgap Light11:26

Integrating a Triplet-triplet Annihilation Up-conversion System to Enhance Dye-sensitized Solar Cell Response to Sub-bandgap Light

Published on: September 12, 2014

13.1K

Related Concept Videos

Making Record-efficiency SnS Solar Cells by Thermal Evaporation and Atomic Layer Deposition14:01

Making Record-efficiency SnS Solar Cells by Thermal Evaporation and Atomic Layer Deposition

Tin sulfide (SnS) is a candidate material for Earth-abundant, non-toxic solar cells. Here, we demonstrate the fabrication procedure of the SnS solar cells employing atomic layer deposition, which yields 4.36% certified power conversion efficiency, and thermal evaporation which yields...
43.3K
Monovalent Cation Doping of CH3NH3PbI3 for Efficient Perovskite Solar Cells08:30

Monovalent Cation Doping of CH3NH3PbI3 for Efficient Perovskite Solar Cells

Here, we present a protocol to adjust the properties of solution-processed CH3NH3PbI3 through the incorporation of monovalent cation additives in order to achieve highly efficient perovskite solar...
17.1K
Integrating a Triplet-triplet Annihilation Up-conversion System to Enhance Dye-sensitized Solar Cell Response to Sub-bandgap Light11:26

Integrating a Triplet-triplet Annihilation Up-conversion System to Enhance Dye-sensitized Solar Cell Response to Sub-bandgap Light

An integrated device, incorporating a dye-sensitized solar cell and triplet-triplet annihilation up-conversion unit was produced, affording enhanced light harvesting, from a wider section of the solar spectrum. Under modest irradiation levels a significantly enhanced response to low energy photons was demonstrated, yielding a record figure of merit for dye-sensitized solar...
13.1K
Dye-sensitized Solar Cells10:30

Dye-sensitized Solar Cells

Source: Tamara M. Powers, Department of Chemistry, Texas A&M University
Today's modern world requires the use of a large amount of energy. While we harness energy from fossil fuels such as coal and oil, these sources are nonrenewable and thus the supply is limited. To maintain our global lifestyle, we must extract energy from renewable sources. The most promising renewable source, in terms of abundance, is the sun, which provides us with more than enough solar energy to fully fuel our...
18.2K
Experimental Methods for Efficient Solar Hydrogen Production in Microgravity Environment11:38

Experimental Methods for Efficient Solar Hydrogen Production in Microgravity Environment

Efficient solar-hydrogen production has recently been realized on functionalized semiconductor-electrocatalyst systems in a photoelectrochemical half-cell in microgravity environment at the Bremen Drop Tower. Here, we report the experimental procedures for manufacturing the semiconductor-electrocatalyst device, details of the experimental set-up in the drop capsule and the experimental sequence during free...
8.1K
In Situ Monitoring of the Accelerated Performance Degradation of Solar Cells and Modules: A Case Study for Cu(In,Ga)Se2 Solar Cells09:19

In Situ Monitoring of the Accelerated Performance Degradation of Solar Cells and Modules: A Case Study for Cu(In,Ga)Se2 Solar Cells

Two 'Combined Stress test with in situ measurement' setups, which allow real-time monitoring of accelerated degradation of solar cells and modules, were designed and constructed. These setups allow the simultaneous use of humidity, temperature, electrical biases, and illumination as independently controlled stress factors. The setups and various experiments executed are...
8.8K