[Analysis and Improvement Suggestions on Change of Medical Devices Licensing Items]

Yongcheng Ren1, Chunxia Yu1, Huadong Wang1

  • 1Henan Provincial Food and Drug Evaluation Inspection Center, Zhengzhou, 450018.

Related Concept Videos

Central Venous Access Device Dressing Change11:56

Central Venous Access Device Dressing Change

Source: Madeline Lassche, MSNEd, RN and Katie Baraki, MSN, RN, College of Nursing, University of Utah, UT
Central venous access devices (CVAD), commonly known as central lines or central catheters, are large-bore intravenous (IV) catheters that are introduced into the central circulation. Typically, CVADs terminate in the superior vena cava, just outside of the right atrium of the heart, but they may also terminate in any one of the great veins (i.e., aorta, inferior vena cava, brachiocephalic...
37.6K
High-throughput Identification of Bacteria Repellent Polymers for Medical Devices10:43

High-throughput Identification of Bacteria Repellent Polymers for Medical Devices

A high-throughput microarray method for the identification of polymers which reduce bacterial surface binding on medical devices is...
9.5K
An Ex Vivo Porcine Model for Hydrodynamic Testing of Experimental Aortic Valve Procedures and Novel Medical Devices06:56

An Ex Vivo Porcine Model for Hydrodynamic Testing of Experimental Aortic Valve Procedures and Novel Medical Devices

We present a method for mounting a porcine aortic valve on a pulse duplicator to test its hydrodynamic properties. This method can be used to determine the change in hydrodynamics after the application of an experimental procedure or novel medical device prior to use in a large animal...
1.6K
Rapid and Low-cost Prototyping of Medical Devices Using 3D Printed Molds for Liquid Injection Molding10:43

Rapid and Low-cost Prototyping of Medical Devices Using 3D Printed Molds for Liquid Injection Molding

We have devised a method for low-cost and rapid prototyping of liquid elastomer rubber injection molded devices by using fused deposition modeling 3D printers for mold design and a modified desiccator as a liquid injection...
20.5K
Production of a Strain-Measuring Device with an Improved 3D Printer06:17

Production of a Strain-Measuring Device with an Improved 3D Printer

This work presents a strain measurement sensor consisting of an amplification mechanism and a polydimethylsiloxane microscope manufactured using an improved 3D...
6.5K
Method for Simultaneous fMRI/EEG Data Collection during a Focused Attention Suggestion for Differential Thermal Sensation06:33

Method for Simultaneous fMRI/EEG Data Collection during a Focused Attention Suggestion for Differential Thermal Sensation

We present a protocol for concurrent collection of EEG/fMRI data, and synchronized MR clock signal recording. We demonstrate this method using a unique paradigm whereby subjects receive ‘cold glove’ instructions during scanning, and EEG/fMRI data are recorded along with hand temperature measurements both before and after hypnotic...
12.3K